SOURCE: disable onstar from 2007 chevy silverado
Call onstar and cancel the service, pull fuses, then remove the top of the dash and unhook the onstar module behind the passenger side airbag. I think it would be much easier just to call and cancel
SOURCE: I just want the onstar disabled.
What do you want to disable the sound when you push the buttons or the service you get when you push it?
I’m happy to assist further over the phone at https://www.6ya.com/expert/joe_a3369546f8067589
SOURCE: 2007 Chevrolet Uplander LT ABS and TC light on
We were having this problem...have your wheel bearing checked out. There was a sensor in the drivers side wheel bearing...once we replaced it (because it was going out) the ABS and Traction Control warning lights stopped coming on.
SOURCE: i have a 2005 chevy equinox i replace the front
check the connections on the abs, behind the rotor by strut is the connection for the abs if the connector is loose or not properly affixed to the clip it sets off the abs trouble code or low speed saftey usually activates at slow speed under 5 miles an hour the connector and clip are part of the abs circuit--also recheck ur brake pads for binding and brake fluid level --if u get a trouble code have vehicle scanned some auo stores such as auto zone / advanced auto scan for free this will tell u which sensor or unit is causing problem
SOURCE: dtc code p0121 and p2135 2007 chevy malibu
both codes refer to the throttle position sensor, the sensor is at the throttle plate, on the side of the throttle body. to test remove the connector to sensor, use a ohms meter to test. put 1 lead to top connection and the other to the bottom one. move throttle and the needles on the ohms meter should move very even, move throttle slow to get a good reading, needle should move without no hesitation, if the test is bad replace tps sensor. if the sensor gets to bad, it can have an effect on transmission shifting. after fixing sensor have the light turned of with an obd2 scanner.
75 views
Usually answered in minutes!
×