2006 dodge dacota radio wiring harness

ck here...

https://www.fiero.nl/forum/Archives/Archive-000003/HTML/20110502-6-065656.html

You can pick it up on the ignition switch.

buy a harness .. much safer , without cutting factory wires

fastest and easiest way to do it would be to get used plugs from the junkyard and then get a wire harness for the radio to fit it, most auto parts stores carry the radio harness.

This is what my books show.
2009 Dodge Ram 2500 Car Radio Install Instructions
Car Radio Battery Constant 12v+ Wire: Gray/Red
Car Radio Accessory Switched 12v+ Wire: The radio harness does not provide a switched power source. Run a wire to the fusebox for switched power.
Car Radio Ground Wire: Black/Dark Green
Car Radio Illumination Wire: Orange/Dark Blue
Car Stereo Amp Trigger Wire: Dark Green/Red
Left Front Speaker Positive Wire (+): Dark Green
Left Front Speaker Negative Wire (-): Brown/Red
Right Front Speaker Positive Wire (+): Violet
Right Front Speaker Negative Wire (-): Dark Blue/Red
Left Rear Speaker Positive Wire (+): Brown/Yellow
Left Rear Speaker Negative Wire (-): Brown/Light Blue
Right Rear Speaker Positive Wire (+): Dark Blue/White
Right Rear Speaker Negative Wire (-): Dark Blue/Orange

Hooked all wires up right??? Fuse is fine??? Somehow, I do not think this is the case. I wish I had a dollar for every time I have seen this happen....I would be a VERY rich man!

You do not need a dome lamp diagram. You need to replace Fuse #13 (10 Amp) in the Power Distribution Center in the engine compartment. This will make the power return to the PINK wire and get your dome lamps working.

The only way that the RED/WHITE wire is going to have power with the ignition switch off is if either the ignition switch is shorted to power or the RED/WHITE wire got hot enough to melt the insulation in the wire harness and short to another B+ wire. This wire is supposed to have power when the ignition switch is in the RUN and ACC positions. Make sure it is in the OFF position. If this wire still has power, then YES, you probably smoked the wiring harness. If this is the case, the dash should be removed so that full access to the wiring harness can be achieved, allowing a full inspection/repair of ALL of the damage (there are most likely several other wires in the harness that have also been damaged).

Hello my name is Israel. I have added the following informaiton to help you out. Good Luck.

Radio 12v gray/red + radio harness
Radio Ground black and black/lt. green - radio harness
Radio Ignition pink/yellow + radio harness
Radio Illumination orange/tan (dimmer) + radio harness
Factory Amp Turn-on N/A
Power Antenna N/A
LF Speaker +/- dk. grn/yel - dk. grn/lt. blue +,- radio harness or amplifier
Notes: The amplifier is behind the glove box.
RF Speaker +/- gray/yellow - gray/lt. blue +,- radio harness or amplifier
LR Speaker +/- gray/lt. grn - gray/dk. grn +,- radio harness or amplifier
RR Speaker +/- dk. grn/lt. grn - dk. grn/gray +,- radio harness or amplifier

This is because you need to purchase the aftermarket-oem harness plug.This harness plugs into your original equipment radio harness and allows you to plug any aftermarket radio into the stock deck wires.After you plug the harness in you can then connect the radio wires together.Your local autoparts store or circuit city or best buy or audio express will have these radio conversion plugs.I hope I could help

good morning and welcome to fixya.

are you installing the factory radio or an aftermarket radio? you can purchase a wire harness for this vehicle that will plug into the factory chassis harness without cutting the harness connector. if your connector is missing the wires in the aftermarket harness are color coded the same as the wires on the factory side. check best buy or crutchfield.com those guys at crutchfield are really great. good luck and let me know if i can help anymore. thank you




please don't forget to rate this solution

all you need is a cheap continuity tester, any one to help tap on the brakes..7pin is just like the 4 pin w/extra power wire for acc.lites,electric brakes.when you buy the 7pin rec.,comes w/wiring schematic standard to all trailer rec.- you can do it..kev-mn.