What is the maximum speed of ford mustang 200 hp 1966

1966 1970 Oldsmobile Toronado

http://www.automobile-catalog.com/make/ford_usa/falcon_usa_3gen/falcon_usa_3gen_futura_sports_coupe/1966.html

just use this site for all your vehcile top speed questions
http://www.automobile-catalog.com/

http://www.automobile-catalog.com/make/dodge/charger_1gen/charger_1gen/1966.html

1962 Ford Taunus 17 M 60 hp: The maximum speed is 135 km/h (85 mph)
1976 Ford Mustang 100 hp: The maximum speed is 173 km/h (107.5 mph)
1978 Ford Fiesta 66 hp: The maximum speed is 145 km/h (90 mph)
1978 Ford Capri 107 hp: The maximum speed is 186 km/h (115.58 mph)

Please note that these speeds are approximate and can vary based on factors such as the car's condition and modifications

The engine is a 200 CID straight six, the firing order is 153624...



Just pop the distributor cap and have someone crank the engine while you watch the rotor.

How I can determine which hole in the distributor is assigned to the #1 plug wire.
Pull the number one plug. Turn the engine over slowly (with a wrench) while holding your finger over the plug hole. When the air builds (a lot of) pressure you are coming up to the number one spot on the distributor. (the rotor will point to the location of the #1 hole in the distributor.)

Quick methods to disable the engine I have seen people do on the classics:
Close the points by loosening the set screw
Pull the rotor cap
Connect a wire from the coil to ground. (effectively closes the points. Can damage the coil if key is left on.)
Pull the main ignition wire
And there are some tricks at the starter solonoid involving the ballast resistor bypass that is used to provide a hotter spark while cranking. (Two little wires at the starter solonoid - one is crank the other is the ballast bypass.)

Might give those a look-see. Best of luck (rememeber rated this help).

your in luck because all repair kits come with instructions
but dont get caried away taking out choke and throttle plates it isnt nessesary just take off the top and bottom and choke assemly clean up parts.blow out passages with air hose were safty glasses in case a check ball you missed or some dirt comes flying out

Hi,
You can remove that center bolt easily with an impact gun. It has normal threads on it. An impact gun will prove to be an affordable tool that you will use again. You can get an electric one from Harbor Freight. They make the job of removing tough bolts much easier. If the engine is in the car, you might not have enough room. You can use a ratchet and if the engine is turning, you can hold the pulley with another tool sold at Harbor Freight called a rubber strap wrench.

faxonautoliterature lists the originalFord service manual for your car for $69 or a reprint for $44. This manual will have everything you need. I have dealt with them before and had excellent service even though I live in Canada. Hope this helps.

Top is a C4, bottom is C6.

What the heck is "rego"? Please translate from UK slang to American English please.
Standard HP is 210
289 cubic inches = 4735 cc

Charlie