SOURCE: what does service system stability mean on my 2001
This refers to the suspension and steering, you probably have a faulty sensor somewhere.
One of the most common sensors to fail in this system is the steering wheel position sensor.
You need to run a diagnostic check to pull the trouble codes to pinpoint the faulty component.
How to pull the codes.....
Use the 3 switches located to the right (LH drive cars) of the Driver Information Center (DIC) to activate and respond to the OBD prompts on the DIC.
ON/OFF = YES
INFO RESET = NO
INFO DOWN or INFO UP = manual toggle
Ignition ON, acknowledge any warning messages;.
Press ON/OFF and INFO UP together for 2 to 3 seconds. Everything in front of you lights up for 4 or 5 seconds, then you will see:
Display shows "ALL?"
Answering YES will display "ALL CODES?"
Answering YES will run automatic test sequence and display codes, if any.
"ALL CLEAR CODES?" will display at the end of the automatic test. If you are satisfied you have the information you need, answer YES to clear/erase all error codes.
Answering "ALL?" with INFO DOWN will toggle systems test manually in order.
Answering "ALL?" with INFO UP will toggle system test manually in reverse order.
Press INFO RESET to reset DIC to "ALL?" to start again.
Ignition OFF to exit.
Write down the codes as they appear on the DIC, you may need to run the check again as it tends to scroll through quickly.
Report back here with the codes.
SOURCE: My cadillac 2oo4 escalade service stability
one or more of your sturst are going bad. you need to have your truck scanned. auto zone scans for free. they should be able to tell you which strut is bad.
SOURCE: i am getting a message
Is the abs light on as well?If so vehicle may have a bad bearing hub assembly.
SOURCE: THE SERVICE STABILITY SYSTEM LIGHT STAY ON, I HAVE
Whats dose it mean went I have my service stability system light on and it dosent trun off .. I have a Cadillac escalade truck 02 All wheel drive hope some one could help me.......
SOURCE: 2001 cadillac deville service system stability
Whenever
this warning or any other stays on in the dash it is indicating that
the systems control module has detected a fault, it then disables the
system as long as the light is on. You must now have the dealer hook
up a special electronic diagnostic tool and "scan" the
system for the fault code that is stored for the problem(s)
Whenever this warning or any other stays on in the dash it is indicating that the systems control module has detected a fault, it then disables the system as long as the light is on. You must now have the dealer hook up a special electronic diagnostic tool and "scan" the system for the fault code that is stored for the problem(s)
498 views
Usually answered in minutes!
×