2002 Chevrolet Cavalier Logo

Related Topics:

Roy Posted on Nov 24, 2016
Answered by a Fixya Expert

Trustworthy Expert Solutions

At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.

View Our Top Experts

Need to no where mass air sensor lccated on a 2002 calvalier 2.2 motor

1 Answer

SeabeeMechanic

Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

  • Chevrolet Master 1,367 Answers
  • Posted on Nov 25, 2016
 SeabeeMechanic
Chevrolet Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Joined: Apr 22, 2013
Answers
1367
Questions
1
Helped
412574
Points
3754

5 Related Answers

Anonymous

  • 291 Answers
  • Posted on May 15, 2008

SOURCE: replace air mass sensor

REMOVE SNORKEL AIR TUBES BETWEEN GRILL AND AIR CLEANER. REMOVE ENTIRE AIR CLEANER--(PULL UP FROM BOTTOM OF UNIT, IT IS JUST HELD ON WITH FOUR CLIPS) AT REAR OF ENGINE YOU WILL SEE A ROUND AIR INTAKE THE SENSOR IS IN THE TOP TUBE. USE FLAT BLADE SCREW DRIVER TO PUSH IN THE CLIP AT THE REAR AND REMOVE THE TUBE UNPLUG THE ELECTRICAL CONNECTION. THE SENSOR IS SCREWED IN WITH 2 TAMPER PROOF SCREWS REQUIRING A SPECIAL BIT (5 STAR WITH A HOLE IN THE CENTER) I GOT ONE FROM A TOOL TRUCK (SNAP ON ETC)

Ad

Anonymous

  • 566 Answers
  • Posted on Dec 20, 2008

SOURCE: Where is the mass air flow sensor located on a jaguar x-type

hi from the uk the location of mass air flow sensor on x type jag is as follows==it is on the r/h/side of the air filter cover with jaguar embossed on top? this sensor is just prior to the intake hose that connects to the motorised throttle body from filter connections underneath it to unplug and meter is held by two screws ?if memory serves ? may i suggest you remove the large hose and use a little wd40 or similar to clean /lubricate the throttle butterfly in throttle body throat at this point so as to prevent future sticking upsetting of idling ? hope this helps ?

c17hydro

Greg Bernett

  • 2993 Answers
  • Posted on Mar 26, 2009

SOURCE: MASS AIR FLOW SENSOR REPLACEMENT & DIAGRAMS

Very easy for the Mass Air Flow Sensor....it is in the duct between the throttle body and the air filter box. Just unclamp the tube and remove the old and replace with the new.

13d0cec.jpg

On your pack....I need the engine size.


Anonymous

  • 2 Answers
  • Posted on Jul 26, 2009

SOURCE: mass air flow sensor is

My check engine light came on and the code came back saying that the mass air flow sensor was out. All I did was change the air filter even though I really didn't think it needed it, the light went off and has not come back on yet. Knock on wood!

oscar ulloa

  • 66 Answers
  • Posted on Sep 16, 2009

SOURCE: 2002 mazda millenia mass air flow sensor

Look in the oulet air cleaner tube, it's hold by 4 nuts.

Testimonial: "Thank you so very much for your assistance. I wish i could ask you alot of other questions!!"

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Why does my 2002 Ford Windstar se idle at 3000 rpms and drop back down below 1000 rpms

The mass air flow sensor, the throttle body and the idle air control motor need a good cleaning. Use a brush and brake clean everything except the Mass air flow sensor, just spray it down, both sides. After you clean it, it will take a few second to restart.
1helpful
1answer

Where is the Mass Air Flow Sensor located in a 2002 Chevrolet Monte Carlo?

mounted on round hose coming off air box to fuel injection unit
0helpful
2answers
6helpful
2answers

2002 mazda millenia mass air flow sensor

MASS AIR FLOW SENSOR IS ATTACH TO AIR DUCT TO AIR CLEANER HOUSING.
2helpful
1answer

Code po102 came up on my daughter's 2002 Buiick Le Sabre the engine is a 3800 v-8

You can remove the mass air flow sensor with some carb cleaner. You will see 2 wires inside of the sensor to clean. If it does not work you will most likely need a mass air flow sensor.
1helpful
1answer

1996 MERCURY GRAND MARQUIS WITH OCCASIONAL SLUGGISHNESS ON ACCELERATION AND SEEMS LIKE IT MAY BE USING MORE GAS THAN USUAL. HAS BEEN WELL TAKEN CARE OF, REG. OIL CHANGES, NEW FUEL FILTER 2 YRS AGO-DR

I would use 10W40 in the 96 and 5W20 or 30 in the 2002.

For the 96 with sluggishness, you need to gently clean the MAF sensor wires with carb cleaner and a toothbrush. It is in the air intake tube. After cleaning, disconnect the battery for 1/2 hour, then reconnect so the computer can relearn the clean sensor. Drive for 10 miles, it will run rough until it relearns.


Section 03-14: Engine Controls, Electronic 1996 Town Car, Crown Victoria, Grand Marquis Workshop Manual
DESCRIPTION AND OPERATION Mass Air Flow (MAF) Sensor The mass air flow sensor (MAF sensor) (12B579):
  • is mounted on the corner of the engine air cleaner (ACL) (9600).
  • uses a hot wire sensing element to measure the amount of air entering the engine; air passing over the hot wire causes it to cool.
  • sends out an analog voltage signal to the PCM (12A650) to determine the intake air mass. The PCM will then calculate the required fuel injector pulse width to provide the desired air/fuel ratio.
The mass air flow sensor hot wire sensing element and housing are calibrated as a unit and must be serviced as a complete assembly.

Mass Air Flow (MAF) Sensor

f314297.gif
6helpful
1answer

2002 Kia Sedona- Mass Air Flow Sensor problems

i had the same problem my car keep seting the code for the mass air flow sensor. i put on 3 of the. and it was not the mass air flow sensor. i had a bad set of plug wires that was making the car set a mass air flow sensor code. my car fine now after a year. make you sure you use kia plugs. if you need anymore help let me know.
3helpful
1answer

Toyota camry sportevo 2002

The inlet air temp sensor is part of the Mass Airflow Sensor, it is located between the engine intake manifold and the air filter box, on the air tube. Easy to get to, unplug it and remove 2 screws.
2helpful
2answers

2002 volkswagon jetta turbo diesel need to know what this trouble code means p3130

you have a bad mass air flow sensor. unplug the mass air flow sensor, the car will run normal if the sensor is bad
Not finding what you are looking for?

86 views

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...