How do I bleed a Honda prelude fuel system. 1999 model,5th generation. Thankyou. E.Whelan.

There is no bleed screw, the system is self bleeding as you crank it over any trapped air is expelled through the injectors nozzles..

-Here some basic.
-Turn the key to on and off couple time. (Do not start).
That all.

Good luck

Mai

The all in one PGM/fuel pump relay is bolted to the upper left hand side of the drivers foot well. It should be gray box with lots of wires coming out of it.

What is the question here?

sounds like your clutch is not engaging all the way

the clutch will not compress till the system is bled, try gravity bleeding then pressure bleeding

The red maintenance light on the 5th generation preludes is simply an oil light. Press your key in the middle of the dash and it will turn green. Nothing to worry about. Internal problems will come up with the check engine light.

Intake valve clearance 0.15mm-0.19mm (6-7 thou); Exhaust clearance 0.17mm-0.21mm (7-8 thou). All measurments COLD engine. 2.2 VTEC Prelude engine 1992-1996, import and UK.

if they both are the 2.0L they are the sme thing.

This prelude model on my experience the cause of in emission either map sensor near the throttle body and the small hose is connected. Next the coolant sensor below the distributor w/ two wires and the fuel pressure is cause by bad fuel pressure regulator at the end of fuel rail or the fuel return line closed. I hope this will give help to you.