SOURCE: where do i find a knock sensor a 1993 gmc sierra
Should be on the right side of the engine by the starter.Has a 1 wire connector.It does not go into the cooling system so you can just take it out without draining the coolant.Hope this helps.Good luck.
SOURCE: i need to be walked
Here have information about #791 bypass module: Bulldogsecurity Model791
IF YOUR REMOTE STARTER IS CLICKING AND/OR
FLASHING THE PARKING LIGHTS AND IS NOT RESPONDING TO THE REMOTE, IT IS
IN SAFE MODE AND NEEDS TO BE INITIALIZED BY DOING THE FOLLOWING:
If you have a 4 button remote, you must ground the black/blue
hood pin
wire (raise hood if hood switch is installed). Apply 12volts to
blue/black brake wire (press and hold brake pedal if wire is installed).
Press and hold any button on your remote until clicking and flashing
stops. Unit will now respond to the remote. Remove ground from hood
pin wire and voltage from brake wire.
If you have a 2 button remote, hold brake and press any button on the
remote until clicking and flashing stops.
ADDENDUM
If
you have an RS1100 or RS1200 and
your vehicle runs for several seconds, shuts
off, restarts, runs, and shuts off again, perform
the following step:
Connect the Black/White tach wire (from the 16 pin plug) to the heavy
gauge White Ignition 1 wire and program the unit for Tach Mode (bottom
of page 19).
Witch model alarm have your vehicle?
Good luck.
Testimonial: "awesome info with lots of extras! went above and beyond the call of duty! "
SOURCE: where is the cabin filter on a sierra 2004 gmc sle
The 04 SIERRA is behind a panel with 4 screws under the glove
box...Remove the screws and cover and slide it out.There is actually 2
in there and it is easy once the cover is off.
Usually there are extremely detailed instructions that come with the
new filter when you open the box...Follow these instructions it
shouldn't be too hard.
SOURCE: how to replace headlight assembly on a 2007 gmc
try t
1
Headlamp Screws (Qty: 2)
Notice: Refer to Fastener Notice in the Preface section.
Tighten
Tighten the screws to 6 N·m (53 lb in)
2
Headlamp Screw (Hidden)
Tighten
Tighten the screws to 6 N·m (53 lb in)
3
Headlamp Housing Support
Tip
Depress the housing support tab with a flat-bladed tool downward in order to release the headlamp assembly from the support.
1
Headlamp Screws (Qty: 2)
Notice: Refer to Fastener Notice in the Preface section.
Tighten
Tighten the screws to 6 N·m (53 lb in)
2
Headlamp Screw (Hidden)
Tighten
Tighten the screws to 6 N·m (53 lb in)
3
Headlamp Housing Support
Tip
Depress the housing support tab with a flat-bladed tool downward in order to release the headlamp assembly from the support.
his.
400 views
Usually answered in minutes!
×