Where is the power window power lock relay located on 1997 Nissan Quest?

Question edited for clarity and the typos - Nissian, cyclinder, vam, and PO 304 is P-zero not P-letter Oh..
Question moved to model category

What makes you think it is the Crankshaft Sensor? This is a simple misfire on Cylinder 4. Check plug, leads and coil. Run some Injector cleaner.

The P0304 code stands for "Cylinder 4 Misfire Detected", which means your vehicle's cylinder 4 has misfired enough times for your powertrain control module (PCM) to notice. A worn spark plug, a faulty fuel injector, and a leaking valve are some possible causes of the P0304 code.
Jul 28, 2023

P0304 Code: Cylinder 4 Misfire Detected - CarParts.com

https://www.justanswer.com/nissan/58ol6-2004-nissan-quest-5spd-where-crankshaft-sensor-located-diy.html

..

Fuse 12 for the brake switch, but it covers a lot of other things as well that would be very noticeable.

Automatic Speed Control Device (ASCD) Brake Switch, Data Link Connector, Combination Meter, Heated Seat Relay, Park Neutral Position Switch, Display Unit, Steering Angle Sensor, Display Control Unit, Navi Control Unit, Back Door Control Unit, Sliding Door Control Unit RH/LH, Sonar Control Unit, Daytime Running Lights, Hands Free Telephone

Nissan Quest (V42; 2004-2009) fuses and relays

Fuse Box Diagrams https://fuse-box.info > nissan > nissan-quest-v42-2004...

Here you will find fuse box diagrams of Nissan Quest 2004, 2005, 2006, 2007, 2008 and 2009, get information about the location of the fuse panels inside the car ...

Missing: 1994 ‎' Show results with: 1994

According to amazon.com,

CAMSHAFT POSITION SENSOR

1997 Nissan/Datsun Truck Quest Mini Van 3.0L FI SOHC 6cyl

The Camshaft Position Sensoris located: Under hood, passenger side, upper engine area, end of intake manifold, mounted in distributor

Power door lock inside door is broken similar to this one

disconnect switches that make the windows operate.
unplug motor then see if the window regulator for the motor has become disconnected.
http://www.jcwhitney.com/1993-1997-nissan-quest/oe-comparable-power-window-regulator-brand-new/p3038536d1697y1993-1997j1.jcwx
this is a picture of regulator.

My guess would be a switch (park interlock, brake interlock, etc.), a main fuse (located under the hood), or a starter solenoid. One easy check is to turn the key to start and simultaneously wiggle the shifter or pull it in to the Neutral position.

Good luck.

For 1997 Nissan/Datsun Truck Quest Mini Van 3.0L SFI 6cyl the Crankshaft Position Sensor is located: Under hood, center, upper engine area, mounted on top front driver side of engine.

Hope helps (remember comment and rated this).

My power window fuse don't work. the window goes down never came up
Any one can help me de to it please ?

If you tried jumping it and it still doesn't start, then it's not your battery. There may be a problem with the solenoid/starter. Try tapping the starter a few times with a metal object (tire wrench or something), but not too hard. Then try starting it again.

hi
I think it was a catalytic converter problem
so change it may be fix a problem
with my best wishes