SOURCE: I have a 2004 Toyota
You have to remove the rear door inside panel.First thing is to remove the top and side interior trim panels,they just pop out by prying them away after they are out the metal retaining clips sometimes stay in the door,pull them out and put them on the plastic panel before reinstalling.Then the strap that you use to close it has a cover on it that you have to push up to get off then remove the 10 mm bolt that holds the strap.Then pry the panel away from the door I think that the bottom has two hooks on it which means that the top needs come off first so you can lift the panel hooks out of the slots.Once the panel is off you will see the bulbs they twist out and you have to pull the bulbs out.Good luck
SOURCE: Reverse lights and license plate light dont work
Try link below, may point you in right direction, but you'll have to scroll down & find what you need. Otherwise I'd start from bumper with test light & work my way back toward front harness, after all fuses, plugs etc been checked.
http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c152800610de
SOURCE: 2002 license plate bulbs
its real simple look at the license plates then look up you will see 2 screw per lamp / unscrew them and slide remove its a 194 bulb so get some ready then replace and put back / Please rate my response thank you very much
SOURCE: how to replace the license plate blub
open the trunk and remove the back panel in the trunk could be a couple of clips or a few screws holding the panel on one you remove the panel you should have easy access to the bulb just twist and remove. or on some avalons you need to pry the lens off the light to replace it then the lens will click back into place with a little push
SOURCE: tail lights and reverse lights out.
Check the bulbs for the tail/brake lights. If you put in single filament bulbs it will be on from the tail light voltage and the brakes will not show.
Try this;
Turn off the lights, press the brake pedal. Look at the brightness of the brake lights.
Now turn on the lights. Look at the brightness of the lights. If is the same as before the bulbs are wrong. You need two filament bulb.
34 views
Usually answered in minutes!
×