Question about 1999 Acura TL
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
My tcs light comes on sometimes along with the check engine light on my acura 3.2 tl. The tcs lt is not on when I start the car, I have to press the button to turn it on. This starting happening rt after I had an inspection service performed. What could be the problem?
Posted on Jan 05, 2009
it's a wire from under the dash it usually burns out after awhile,i had the same problem email me at email@example.com for more info on the wire i forgot the name for it.
Posted on Jun 13, 2009
The wires in the seat heater will burn out if they are left on HI for too long. You can take the seat out of the car, remove the seat covering, and solder some new wires in place of the fried ones. Then put it all back together and hope you don't get a shock in your **** when you flip the switch for the first time. I just did this to my 2000 TL today and it took about 3 hrs to get it all worked out. For step by step instructions go to: http://joshsworld.com/cars/acura-tl-seat-heater-fix/
Posted on Jun 13, 2009
Below are the proper steps to removing your vehicle's fuel tank..
Disconnect the negative battery cable.
Relieve the fuel pressure
Remove the rear seat cushion.
Remove the plastic grommet from the floor pan.
Detach the fuel pump electrical harness.
Disconnect the fuel lines from the fuel pump by compressing the tabs on both sides of each nylon push connect fitting and easing the fuel line off of the fuel pump.
Raise and safely support the vehicle securely on jackstands.
Remove the muffler mount.
Remove the heat shields.
Remove the fuel tank cover.
Remove the drain plug and drain the gasoline into a approved container.
Disconnect the fuel lines and remove the fuel filter and base.
Loosen the fuel tank filler pipe clamp at the fuel tank.
Support the fuel tank using a hydraulic jack and a block of wood or other suitable device.
Remove the two fuel tank support strap bolts and position the straps out of the way.
Partially lower the fuel tank to access the fuel tank filler pipe vent tube and disconnect the vent tube and filler pipe from the tank.
Disconnect the fuel vapor tube from the tank.
Lower the tank from the vehicle.
Installation is the reverse of the removal procedure.
Posted on Apr 23, 2010
Tips for a great answer:
Jan 08, 2016 | 1998 Acura CL
Oct 04, 2014 | 1999 Acura TL
Oct 19, 2012 | 2000 Acura TL
Mar 24, 2010 | 2004 Acura TL
Jul 10, 2009 | 1999 Acura TL
Dec 24, 2008 | 2000 Acura TL
Dec 18, 2008 | 2000 Acura TL
Dec 08, 2008 | 2000 Acura TL
70 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: