Where is the cam shaft position located at on a 3.0 liter engine is ?
SOURCE: 1997 Dodge caravan crank position sensor
it is located on the bellhousing of the transmission it gets its signal from the flywheel.look where the transmission bolts to the engine.
SOURCE: Cam Shaft Sensor Problems
Had the same problem before on my 04 Neon SXT...camshaft sensor is on left side of engine block, take out the battery and to the left of it (face car) is the camshaft position sensor. To change it you'll have to move a few hoses but its plan to see there on the left side of the engine...pretty easy remove and replace. Fixed my problem of car not going above 2k RPM when i replaced the sensor.
SOURCE: transmission input speed sensor location
It is located on the front of the transmission. you will see 2 of them one on the left under small transmission lines it is the input then to the right behind the radiator overflow there is the other one. Easiest way to change them is with a 1" deep well socket
SOURCE: location of oxygen sensors on 2002 dodge grand
The o2 sensors are located on the exhaust system.The upstream in on the rear exhaust manifold and the down stream is in front of the catalytic converter.Usually when they are bad they will make the check engine like go on.Make sure the air filter is clean,tires at correct inflation,alignment is to specs.If the vehicles pulls to one side or the other or steering wheel is not straight when driving down a straight stretch of road.Also tires are wearing normal.Use cruise control where ever on highway.If you let your vehicle warm up in winter.This also uses gas.Hope this helps.Good luck.
324 views
Usually answered in minutes!
×