No blinker lights, car want turn over but the starter and alternator is good
SOURCE: tail lights not working while drive. brake,blinkers work
i have a crown victoria with brake lights no tail lights could you help me?
SOURCE: 2004 ford ranger wont start battery good starter
yes the clutch safty switch completes starter circuit to test just jump switch with a paperclip if truck starts switch is bad
SOURCE: how to trouble shoot starting system 98 ford crown victoria
Also check to see if there is power in the start wire form the ignition switch, the wire is a white wire with pink stripe, most likely not a common problem, but still something that could go wrong. this wire will feed the starter relay under the hood...
SOURCE: '96 ford Crown Victoria....No hazard or brake light no turn sigal
Sounds like the multifunction switch. Try working the hazard switch up and down a few times to see if you get some lights to work. If so then replace the switch.
SOURCE: where is the neutral safety switch located on 1998
On 1992 and later models, the neutral safety switch is incorporated into the Manual Lever Position or Transmission Range MLP/TR sensor.
Fig. : Adjusting the MLP sensor (click image for zoom)
RENOVAL & INSTALLATION
To install:
ADJUSTMENT
Park is the last detent when the manual control lever is full forward. Return 2 detents toward the output shaft for Neutral.
Hope this helps (remember to rating ans leave a testimonial commnet about this free answer).
Testimonial: "Hey thanks very much...you must have had one a these crown vic's....I must get a manual for sure as I intend to keep her for a time. Thanks ZJ Limited"
84 views
Usually answered in minutes!
×