2002 Accent new starter rubs or not retracting. Making too much noise to hear starter spinning when running and found fine filings Ran quiet before.

Colin Stickland

• 22516 Answers
• Posted on Nov 18, 2008

SOURCE: ticking noise coming from car when cold

are they hydraulic tappets?? not adjustable but a mechaniics bodge if they are hydraulic ,,,,put a 5 sec squeeze of washing up liquid into oil filler and half a litre of diesel -----run for about 2/3 days without doing any boy racer stuff ,,,drain oil and refill with a diesel grade oil like shell rotella or anything cheap off of the supermarket shelf and refill with this and add some more washing up liquid .run for a couple of weeks then change oil and filter .and refill with a cheap diesel/petrol oil from supermarket and change oil every 6000kms or 5000miles or a least once a year more frequent if low mileage .this should free off the build up of gum in the hydraulic tappets without stripping the engine.expensive oil is well known for causing this as poly methyl methacrylate which is used to hold the oil viscosity has a nasty habit when full of crud from not changing oil regulary to clag up.moral of story change oil often but a filter every third oil change

SOURCE: 2001 Hyundai Accent new rear brake noise

jack up the rear wheel and spin it, do this with the other wheels chocked for safety, and listen for any rubbing sound, do this with both rear wheels and if one is bad then remove the drum again to check if the retainer has come off of the brake lining, hope this helps you.

SOURCE: 2009 Hyundai Accent starter motor doesn't turn off

Sounds like the solenoid. You know you have Roadside Assistance with your new Hyundai. Have it towed in and get it diagnosed & repaired under warranty.

SOURCE: 2001 hyundai accent 1.5 liter SOHC 12v engine.

With regrets, Not likely, pull the vlave cover and observe the height of the valves, if it is bent it should be not quite as tall as the rest.

SOURCE: 2002 hyundai santa fe - engine noise ticking

The cam chains have developed slack and are slapping on the cam chain guides which helps prevent the cam chains from popping off in case of slack developing . The chain guides are made of some type of plastic material and develop significant wear.