SOURCE: Shake in steering wheel
I believe you need your disk brake rotors turned to be true again or have them replaced. Whe you use your brakes a lot and kit puddles of cold water then it will warp the rotors which will cause the violent shaking. You may not feel it in the brake pedal even if it is warped rotors. If you don't think you have warped rotors then you should be very careful driving it because it will probably be in the steering sector arm or the idler arm on the steering shaft.
Dale
SOURCE: Stiff steering
Check fluid and make sure it filled enough,(make sure that its actually power steering fluid in there and not something else added by mistake for ex. antifreeze etc) make sure there are no leaks. Check power steering belt and and make sure its tight NOT loose or slipping. From personal experience with these vehicle you MOST likely cause of this problem if all the items above are GOOD is a bad power steering pump.
SOURCE: locked steering wheel
try to spray inside the key lock cylinder (the place where u put ur key ) by PB puster or WD40 then turn the steering wheel lift and right with try to turn the key to position on
i hope this will help
SOURCE: igition won't turn and steering wheel is locked
remove the plastic covers from steering wheel,there is a little hole if you use a small pick and push up on the lock.
SOURCE: How do I change brake light bulb on 2005 Nissan Altima
The first objective is to figure out which bulb you need. I had to replace the bulb for the largest light which was a Sylvania 3157. The next objective is to remove the dang plastic carpet holder/net clip. Recognize that it is a two part piece. Use a flathead screwdriver for leverage. Pry the cap off by levering the screwdriver in the slot on the holder. Then go behind the carpet and pinch the plastic pin still holding the holder in place. Next,pry off the while plastic pieces from the two bolt/nuts you'll need to remove (see manual). Remove the nuts and give the two screws a push from the inside so you can see how the whole light casing comes off. Pry it off from the outside. On the backside of the bulb holder, turn bulb base counterclockwise and gently remove. Pull bulb upward and replace. Do not touch glass on new bulb with your fingers (wear non-powdered rubber gloves). Make sure the bulb snaps in place. Follow these instructions in reverse. Smile, you just learned something new and saved yourself some easy money.
55 views
Usually answered in minutes!
×