2002 Jaguar X-Type Logo

Related Topics:

Robert Stacey Posted on Sep 27, 2016

What does cranking neutral/drive fault mean as shown on a code reader for my Jaguar x type 2002

5 Related Answers

Anonymous

  • 324 Answers
  • Posted on Nov 26, 2008

SOURCE: fuel pump relay 2002 Jaguar x-type 2.5

in the mass fuse box, under the dash, unless you have the manual you will not beable to tell wich one it is.. get a chiltons repair manual or a haynes...

Ad
raygin

Raygin

  • 322 Answers
  • Posted on Apr 07, 2009

SOURCE: Jaguar S Type 3.0 SE Fault code P0430

Code PO430 could be = catalyst efficiency below threshold bank 2 ........ this may be caused by faults in combustion and if you have just completed repairs it may rectify itself as the car runs correctly ...... do not leave as a fault for too long as damage will occur to cat/conv.

Anonymous

  • 52 Answers
  • Posted on May 10, 2009

SOURCE: Gearbox fault of Jaguar S Type

unfortunately when that code, and that gear box fault light comes on, its pretty much game over for the transmission. It only a matter of time before performance of the transmission gets worse and worse. BUT that transmission is VERY easy to replace, i would check out a few trustworthy independent shops to give you a better price! I am usually a die-hard dealership, having been working at this jaguar land rover dealership for the last 2 years, but you are pretty much for sure going to be a cheaper price on the labor and like i said it is a pretty easy task.

My only precaution MAKE SURE IF YOU GETTING A USED TRANSMISSION THAT YOU GET SOME TYPE OF WARRANTY ON IT. Too many times have I seen customers loose thousands of dollars paying someone to put a used engine or transmission and have it fail almost right away.

Anonymous

  • 1 Answer
  • Posted on Aug 10, 2009

SOURCE: x-type jaguar automatic (gear box fault)

I have a 2002 X type (2 litre. done 44000 miles), dash showed gear box problem, (red circle light up). I pulled out and turned the engine off. 5 minutes later turned the engine on. The engine running but the car would not drive either in drive or reverse. Turned the engine off again and on the car driving but not much power. The care is taken to the Jag. dealer and told is misfiring + some gear box faults. Suggesting to change some coils and see (cost about £200+). also possible need to change the gear box costing about £2500+. Please advice. Shall I go ahead with the repair? Should I part exchange.

Anonymous

  • 386 Answers
  • Posted on Nov 02, 2009

SOURCE: What does it mean when ABS Fault and disc light on

it means you need to have it daignosed, you have a malfunction in the ABS brake system, could be anyone of a number of things, abs module, wheel sensors, etc...

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

What makes a 2002 jaguar x type 3.0 to read engine system fault fail and gearbox fault

you need to get the fault codes out of the engine control module and the transmission control module ie ecm and tcm with a eobd fault code reader to help sort this one . common probs are faulty jatco auto gearbox (rubbissh gearbox) poss engine managment sensor failures or even a broken/corroded wire or connector, good luck,.
0helpful
1answer

Auto Transmission Fault. Fault Code Showing "Power train Malfunction"

yor car has got the troublesome jatco gearbox. you need to get someone with a code reader to get the fault codes out of the tcm {transmission control module} may be just low fluid level or selector cable jgate problem but more than likely the box has failed and needs replaced/repaired
0helpful
1answer

Problems as follows. 879 900 9317 5922 197 9681 0401

Not Jaguar OBD fault codes I'm afraid, most likely your code reader is at fault. You need to have them read with a suitable OBDII complient reader.
4helpful
1answer

What does the service code p1111 mean?

Copied directly from a Jaguar forum:

P1111 is not a fault code. It is a special designator Jaguar uses meaning system ready, drive cycles completed after the last fault event. P1000, on the other hand, means system not ready, or drive cycles not completed after the last recorded fault event.

Some OBD II Basics - All P0xxx codes are generic and uniform across all manufacturers and mean the same on every car. All P1xxx codes are manufacturer specific codes. You cannot use a generic code chart to analyze P1xxx codes for a Jaguar.

Next time your car displays an engine fault light, try reading the codes then. If you have a CEL illuminated and the only code read is P1000 or P1111, then you probably have a fault that generic code readers cannot see. Could be a chassis code, for example.

One last thing - Neither P1000, nor P1111 can be erased.

Hope this helps you.
0helpful
1answer

P1646 how much to repair

P1512 Throttle Position Sensor Idle Switch Sense Circuit

P1513 Throttle Position Sensor Idle Switch Sense Circuit

P1514 Park/Neutral Position Switch High Load Neutral/Drive

P1516 Gear Change Park/Neutral Malfunction

P1517 Engine Cranking Park/Neutral Malfunction

P1607 MIL Output Circuit

P1608 Automatic Transmission

P1609 Internal ECM Error

P1641 Fuel Pump Relay No. 1

P1646 Fuel Pump Relay No. 2

P1739 Automatic Transmission

P1775 Transmission Control Module MIL Circuit

P1776 Torque Reduction Request Signal

P1777 Torque Reduction Circuit

P1780 Automatic Transmission

P1781 Automatic Transmission

P1782 Automatic Transmission

P1783 Automatic Transmission

P1785 Automatic Transmission

P1790 Automatic Transmission

P1791 Automatic Transmission

P1792 Automatic Transmission

P1794 Automatic Transmission
P1796 Automatic Transmission
as you can no such code exists for a jaguar ,contact code reader manufacturer

0helpful
1answer

Fault codes c1288 and c1289

after a year of disply Dsc faulty at least we have found someone who can find a code reader is c1288 and c1289, but problem is i dont know how to remove them and what they mean
help please
0helpful
1answer

What are common reasons for the check engine light commming on, on a 2002 2.5 x-type sport

there could be many things causing your check engine light to come on . you would
need the fault code stored in the computer before anyone could tell
you anything about why the light is on. however if it runs and
drives normally its probably not to serious, stop by your local repair shop or buy a code reader and see what the codes are..
1helpful
1answer

How much to repair fault codes p0116, p0121 on 2002 x-type jaguar

You can check the fault code meanings at http://www.bluejag.co.uk/ this should give you an idea of repair costs
0helpful
1answer

Jaguar X SE 2.5 gearbox problem

hey johnhoile,

Sorry to break the bad new to you, put you most likely need a transmission depending on what codes are stored in the system. I have dont numerous automatic transmission on x-types all they all started with a gear box fault light on.

If the codes have something to do with a incorrect gear ration that is a guarantee red flag for a new transmission
Not finding what you are looking for?

110 views

Ask a Question

Usually answered in minutes!

Top Jaguar Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Jaguar Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...