1994 colt vista wiper int relay location

Susan; It could be one of three locations, under car along frame rial, under hood engine compartment mounted on fire wall, or under hood mounted near shock tower. below 2nd link shows the filter assembly and partial harness to help identify location.
press the helpful button

Dodge Colt Repair Manual Service Manual Online 1990 1991 1992 1993 1994

FUEL FILTER 35 VISTA CZ for 1993 PLYMOUTH COLT

How To Replace Fuel Filter

How to Change Your Fuel Filter

The fuel filter is under the hood, in the middle of the upper firewall, mounted in fuel line.

on the wiper motor usually. if it has multiple wires connected to it, it's there

Click on the following: direct, free Link. It has the Timing Belt Marks for your 1994 Dodge Colt; with the unspecified 1.5L or 1.8L SOHC In-Line 4-Cylinder Engines.
After looking at the Diagrams, if you are having a problem with locating the marks on the Cam Sprocket LOOK at the Camshaft Key location at the center of the Camshaft Sprocket Bolt in relation to where the Mark should be.
There are several additional diagrams on the Link Page which will be help you in your endeavors.

Let me know if this helped.

http://www.2carpros.com/car_repair_information/year/1994/make/dodge/model/colt/1994_dodge_colt_timing_belt_diagram_marks.htm

From the service manual, which is available relatively inexpensive at Promanuals.net here


Both front wiper relays are located in the IPDM E/R (intelligent power distribution module engine room)

Wiper switch (combination switch) is composed of a combination of 5 output terminals and 5 input terminals.
Terminal combination status is read by BCM (body control module)

BCM controls front wiper LO, HI, and INT (intermittent) operation

IPDM E/R operates the wiper motor according to CAN communication signals from the BCM.
Power is supplied at all times

through 50A fusible link (letter f , located in the fuse and fusible link box)

to BCM terminal 70, and

through 20A fuse (No. 39, located in the IPDM E/R)

to front wiper relay, located in the IPDM E/R
With the ignition switch in ON or START position, power is supplied at all times

through 10A fuse [No. 1, located in the fuse block (J/B)]

Frist check your fuses.

ECM IS UNDER DRIP TRAY BETWEEN ENGINE AND PASSENGER WIPER.

Answer may be close to here:

http://pdftown.com/PDF-Mitsubishi-Colt-Lancer-1992-1996-Workshop-Manual.html

GL

Try looking in the fuse box. Hope this helps.

could be turn signal relay or one of the bulbs is bad that will do it to but more likely relay.