At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Could be in the switch not making good contact.Could be the safety switch on drivers door.But if the window on the other side works its ok.If you have a switch to let down the window on the driver's side and the door itself and neither one let the window down its a fuse or loose wire inside door.I wouldn't think from the age of the car that's the problem
Other systems that may be affected include: cruise control, push-button start, gear shifter, and Electronic Stability Control (ESC) system. Dealers will replace the brake light switch to correct this concern. ... The stop lamp switch may fail, affecting many vehicle systems including ...
REMOVE DOOR PANEL AND TRY TO ROLL UP, LISTEN FOR THE MOTOR. IF NOTHING THEN REMOVE THE MOTOR AND TRY TO OPERATE IT IF THE MOTOR WORKS WHILE OFF THE CAR THEN I WOULD REPLACED THE WINDOW REGULATOR.
With your key in the ignition, do not turn it, open the fuse panel by the drivers side door, pull out the 30amp P/CONN fuse at the very bottom (mine was in a weird yellow casing) then plug it back in. The disk drive of the radio should make a noise. Now start your Tuscon and turn on your radio.
Sounds like the acutator that pushes and pulls. either lost power or died. I would assumed died. U need to check to see if it is on a seperate fuse first, it may be. If the fuse is ok, remove the hatch inside plastic panel and arm and disarm the alarm. See if the actuator moves.
1.Remove the switch from the door trim panel.2.Check for continuity between the terminals. If continuity is not as specified in the table, replace the power window switch.POWER WINDOW MAIN SWITCHWINDOW LOCK SWITCH
×