How do I wire wire a new pioneer radio/cd player in my 1987 dodge aries le?

copy and paste
https://www.2carpros.com/questions/dodge-aries-1988-dodge-aries-timing

https://www.justanswer.com/dodge/1ghf5-timeing-marks-1987-dodge-aries.html


..,

Right behind housing at front of engine where top rad hose connects.

There's a bolt and a plate near the bottom of the battery holding the battery in the tray. Did you take that bolt out and lift the plate ?

I am currently working on the same car, the one im working on is a K though (wagon), but same engine. What I found the issue to be is a bad fuel line.

Most aftermarket pioneer cd/radio decks have the electrical connector for the antenna that I've seen.

Is this a cd only deck, or does it have radio functions?

Did you use a new harness wiring adapter to get the pioneer radio to work with the old harness?
There should be a color coded set of wires for the power antenna on that. And, then the Pioneer radio should have wires that were labeled for the power antenna.

Check to see if it's fire or fuel. Take one spark plug wire off and put on spare new plug, Place spark plug on engine where the tip is grounded against block and while someone trys to start car check to see if there is spark arcking between tip and insulator on plug. it,s best to do this in the dark. if it sparks, try putting a little gas in intake then try to start if it starts or trys to start, yo know it's a fuel problem. Change fuel filter first, f no change check fuel pump. If no spark check ballast resister on firewall or fender

if your putting in an after market radio,you need to go to walmart and buy a wire adapter for your year and make of car

In center of throttle body near top, below pressure regulator. 2 wires running to it.

If your installing a stock radio/cd player from another Dodge the wiring plug is the same and will fit.If your installing a aftermarket radio/cd player(JVC,Pioneer,etc)you will need to buy a adapter plug that wires up to the radio and is a direct fit to your factory wire harness,so your not cutting your wires.When you buy the adapter plug it comes with a wire diagram of which wire is what.Your aftermarket radio should have a diagram also,either on it or in the manual.Hope this helps you.

I'm trying to remember honest ! Had same. Push set button & hold on time, then turn station button?
If You can take a picture of the face of the radio it might help.