2000 Kia Sportage Logo

Related Topics:

Louie Mendoza Posted on Sep 10, 2016

I have a 2000 kia sportage i just replaced the starter but forgot how and where to connect the 2 wires Can anyone show me where theygo please

5 Related Answers

Anonymous

  • 32 Answers
  • Posted on Sep 28, 2008

SOURCE: sluggish performance on 2000 Kia Sportage

My theory is that it could be the injectors clogging. You could first try running a higher octane fuel, then if that doesn't seem to help try using the minimal amount of gas, and add injector cleaner to the tank. If all of this fails to work you can take your vehicle to the dealership where they can run a system analysis on it and help you pinpoint the problem. Hope this was helpful. Please rate my solution, thanks.

Ad

Anonymous

  • 3 Answers
  • Posted on Dec 05, 2008

SOURCE: REPLACE STARTER IN 1999 KIA SPORTAGE?

at the right side of the vehicle under the battery there is the starter bolted by three screws you need to get under the vehicle to loose the screws use a 14mm socket and wrench to get the bolt loose it takes a bit of maneuvering to get it out of the tight space but it is possible and simply reverse to get the new one in remember to disconnect the battery and the lines to the starter before starting to work.

Anonymous

  • 7 Answers
  • Posted on Feb 13, 2009

SOURCE: Removal of starter for a 2000 Kia Sportage

YOU HAVE TO DO IT FROM THE BOTTOM THERE IS 1 12mm BOLT AND 1 NUT AND IT SHOULD COME OUT

Anonymous

  • 2559 Answers
  • Posted on Feb 14, 2009

SOURCE: 2000 kia sportage ex, 4 cyl.

Yes there is a sensor that controls Fuel/air ratio.It's called a MAF (mass air flow sensor)
But I think you should have the EGR (Exhaust gas recirculation)valve checked
and The TPS (throttle position sensor)maybe dirty.

Although may things can cause this issue,I would look at the items above first.


Please rate this a blue fixya

John Bombardier

  • 3 Answers
  • Posted on Apr 05, 2009

SOURCE: i need to replace the starter on kia sportage and

go to www.kiatechinfo.com sign up it's free great place no one makes a repair manual for us, hope this helps

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1helpful
2answers

My 2007 kia sportage clicks sometimes will start sometimes not any ideas what to check

Hi, i would have the starter motor checked out the click usually comes from the starter solenoid. It could also be a bad main wire connection at the starter from the battery.
0helpful
1answer

2000 Kia Sportage will not turn over...why

Check connections to starter motor and solonoid. A wire could of been dislodged while replaceing the belt
0helpful
2answers

Change starter on 2000 kia sportage

Here's a link to show you how to replace your starter.
0helpful
1answer

On the Kia Sportage 2000 starter motor there are 2 wires, to what connection does those 2 wires go to and does these 2 wires go together on one terminal? There's another wire but that is obvious. I...

both wires go to the same terminal ,the bottom terminal goes into the windings on the motor and the other two go to the top terminal and the little one to operate the solonoid
2helpful
2answers

2000 kia sportage. replaced starter, battery, alt. Timing belt in great shape. I only get a click when trying to start. Any ideas?

get a socket to fit the crank pulley nut and try turning over the engine by hand if it turns you might have a bad cable to the starter or bad starter but if you cant turn it this means its locked up and seized no good.
1helpful
1answer

Putting a starter on a 2000 kia sportage\r\nwhere does positive wire go

the positive wire always goes on to the larger bolt on the solinoid there will be 2 one big and 1 small normaly the positive is held on by a 13mm spanner size nut .
0helpful
1answer

Starter for kia sportage 2000

  1. Before servicing the vehicle, refer to the precautions at the beginning of this section.
  2. Drain the engine oil.
  3. Remove or disconnect the following:

    Negative battery cable Intake manifold bracket upper bolts Clutch release cylinder and move it aside, if equipped Intake manifold bracket lower bolts and remove the bracket Starter from the clutch, manual transmissions only Starter from the torque converter, automatic transmissions only Starter electrical connectors Move the transmission wire harness aside Starter


    0900c152801b0603.jpg enlarge_icon.gifenlarge_tooltip.gif Fig. Exploded view of the starter

To install:
  1. Install or connect the following:

    Starter to the engine well Starter electrical connectors Lower intake manifold bracket and install the upper bolts Starter into position. When aligned properly torque the bolts to 40 ft. lbs. (54 Nm). Torque the intake manifold bracket bolts to 40 ft. lbs. (54 Nm). Properly position the clutch release cylinder, if equipped. Torque the bolts to 40 ft. lbs. (54 Nm). Torque the intake manifold bracket upper bolts to 40 ft. lbs. (54 Nm). Negative battery cable
14helpful
2answers

Removal of starter for a 2000 Kia Sportage

YOU HAVE TO DO IT FROM THE BOTTOM THERE IS 1 12mm BOLT AND 1 NUT AND IT SHOULD COME OUT
0helpful
2answers

2000 kia sportage charging.

hi check the main alternator charigng wire the comes out of your alternator see if it is sending a 14v no less reading on a multimeter if not replace the alternator if so go to your battery see if the multimeter readings are the same as the alternator if so do a battery discharge test if not trace the path of the main wire which comes from the alternator to the battery for breaks and all connections yates210456
Not finding what you are looking for?

144 views

Ask a Question

Usually answered in minutes!

Top Kia Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Brad Brown

Level 3 Expert

19187 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Kia Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...