Ok so I replaced the plugs, the wires, the ignition coil, distributor the rotor and the cam sensor but as I drove to work today it did the little pause then resumes like the engine was stalking out. And leads?
Watch the video. Ignition Pick Up Coil Sensor Replacement How to Dodge Dakota
This Video applies to all models that use the 5.2L V8
SOURCE: 2001 Dodge Ram 1500; how to reset computer after replacing dead battery
disconnect the positive battery cable for 2 minutes and that will reset the computer
SOURCE: 1992 dodge 318 engine turns over, but no start. No
if truck has a ceramic ballist resistor near and connected to coil this could be problem or the crk posistion sensor could be too, i would change ballast first if you have on your truck appx cost $10
SOURCE: 98 dodge 1500 ram speedometer not working sender
ABS LIGHT ON AS WELL?IF SO..I WOULD LOOK AT ABS SENSOR IN REAR DIFFERENTIAL..GETS SPEED SIGNAL FROM THIS SENSOR AS WELL..USES ONE IN TRANS FOR TRANS SHIFTING
SOURCE: 1999 Dodge Ram 1500 Pickup error code p0171
This code means that system to lean, bank 1.
some of the possible causes to make this code set are
1. intake or exhaust leak,
2. problem with the air system.
3. MAF (Mass Air Flow sensor)VAF sensor (Volume air flow sensor)
4. fuel pressure/pump
5. injector(s)
6. HO2S (Oxygen sensor)
SOURCE: how hard is it to install pickup coil in the
The pick-up coil/stator is easily replaced in a dodge distributor, and once you have removed the distributor cap and the ignition rotor, then just dis-connect the wire connector from the pick-up coil/stator and lift it straight up and out of the distributor, and the distributor does not have to be removed or dis-assembled to replace the pick-up coil/stator. There are two alignment tabs on the pick-up coil/stator that will match up with the distributor cap when the pick-up coil/stator is properly installed. Here are two images to help assist you.
1,803 views
Usually answered in minutes!
×