B2293
Pinpoint Test H: LFC 19 and 21/DTC B2293 - Restraint System Airbag Status
Normal Operation
The restraints control module (RCM) checks all of the front air bag circuits for faults. If the RCM detects one of the following faults on any of the front air bag circuits, it will store diagnostic trouble code (DTC) B2293 in memory and, depending on the fault, flash either lamp fault code (LFC) 19 or 21 (or higher priority code if one exists) on the air bag indicator.
Fault Conditions
The RCM monitors for the following fault conditions:
Possible Causes
A driver air bag status fault can be caused by:
A passenger air bag status fault can be caused by:
21
Restraint System - Air Bag Status (Passenger Front Air Bag Circuit Fault)
Go To Pinpoint Test H .
SOURCE: 2003 Mercury Mountaineer no heat
no you have to remove the vent between the hood and the windsheild its on the out side of the car it sounds like your freshair vent is stuck open
SOURCE: 2003 mercury mountaineer lose power when
Hi, maybe there's a problem in your starter or your battery consume more electricity.
NephetZ
SOURCE: cabin filter location mercury mountaineer
There is one for the 2003 Mercury Mountaineer. If you are smellign a "vinegar" odor, mix a solution of 1 part bleach to 3 parts water and pour it down the grid at the base of the windshield. It will take care of the smell.
SOURCE: 2007 FORD RANGER TROUBLE CODES #B2292, B2293
These 3 codes have to do with restraint system.
B2292 Seatbelt pretensioner fault.
B2293 Passenger front airbag fault.
B2691 Seatbelt buckle switch circuit fault Ft.driver side.
SOURCE: Have a code on my Mercury Mountaineer 2003. 02
I would agree with that diagnosis. What was the code number?
P0xxx
Testimonial: "Great response.Thanks again."
762 views
Usually answered in minutes!
×