SOURCE: 1999 nissan quest
Rigoe the points for the timing belt are usually located on the sprokets in conection with marks or dots on the engine block some where around the sprockets that hold the timing belt. Remenber to bring the piston number one to TDC (top dead center), this means you have to locate the piston number one, take the spark plug out and turn the cranshaft (the one with the pulley) by hand until the piston is all the way up. On the distributor the rotor should point to the spark-plug wire number one (you can make a mark outside of the distributor cap where the number one spark-plug wire is pointing so when you take the cap off you can see if the rotor is pointing the same direction). With the timing belt cover off you are going to be able to aling all this points at the exact locacation all together. So we have: Piston number one at TDC, The rotor(enside the distributor cap) pointing to the number one spark-plug wire, and the mark of the sprockets pointing the marks of the engine block( litle dot or dash). If you get all this right you are have done a good job and ready to make a trip you can get all this just by turning the cranshaft by hand with a rachet and a big socket. God bless you.
SOURCE: Where is the Master Cylinder located on a 2000 Nissan Quest?
you will find it when you lift up the bonnet ,say it is in front of the steering wheel,you will notice it by a reservoir of oil,
SOURCE: 95 nissan quest front passenger side power window does
driver side switch is not working replace it
SOURCE: 1997 nissan quest camshaft sensor where is it & how to replace it
The camshaft sensor is located inside the distributor and is part of it, in order to replace it you must replace the distributor,to replace remove the dist cap. mark the location of the rotor,by marking where its pointing to, then mark the dist housing, so now theres a mark on the rotor and housing to show where rotor points, next mark the location of dist going into housing, mark the shaft and the block,because it spins in block this way you can line back up.next remove hold down bolt and pull out,mark the new dist in exacat same spots as the old so you can install back the same,you may have to put it in and pull it out until your marks are lined up,this way the timing will be dead on, when done you can check timing. good luck
SOURCE: Quest. Where is the engine number located?
It's stamped on the engine,you will have to look for it,only info I could find,call the dealer and ask for parts,they will tell you for free.
351 views
Usually answered in minutes!
×