Where is the Crankshaft Position Sensor location on a Town and Country with the 3.6L V6 engine?

Question edited for clarity

Not easy to get to or change according to this.

https://www.justanswer.com/mitsubishi/5693h-crankshaft-position-sensor-located-2003-montero-is-diagram.html

More
https://www.google.com/search?q=2002+montero+sport+xls+2wd+3.5+v6+crankshaft+sensor+location

..

Watch the video of the replacement job 2004 Hyundai Sonata Optima V6 2 7 crankshaft position sensor location and...

Hi. The crankshaft position sensor is located on the intake sector of the engine block, near the flywheel.This will be on the AAA engine build.

On the ABA build, The crankshaft position sensor is mounted on the side of the engine block, near the crank pulley.

when looking at the left hand side of the engine ( from the front or belt side ) it would usually be down on the block to the side of the crankshaft damper pulley and 4-5 inches back from the front of the engine.

crankshaft position sensor location for 3.3 V6 engine is mounted at the rear of the engine on transmission bellhousing, the 3.5 V6 engine crankshaft sensor located at front of the engine on the aluminum oil pan section below crankshaft pulley.replace the crankshaft position sensor remove heat shield disconnect the electrical connector the remove sensor retaining bolt then remove crankshaft sensor.after replacing crankshaft sensor you need to erase code if check light come back on.

CRANKSHAFT POSITION SENSOR IS BEHIND CRANKSHAFT PULLEY.YOU HAVE TO REMOVE CRANKSHAFT PULLEY TO REPLACE THE CKP SENSOR.

Hello sam adamzz: My name is Roger and I will help you. You can locate the crankshaft position sensor in the transmission bell housing. Standing at the driver side fender. Look at the back af the engine where the transmission and block meet. Just to the right of the block edge mounted in the bell housing you should see a round sensor with a wire lead out of it. This should be the sensor you want. Should you need further help please just ask. Please rate the answer. Thank You for using Fix Ya. Roger

I have same issue on my 2003 TC - 3.8L Van. Do you have a picture of the CPS location?

it is on the front of the engine down low, here is a picture.