I need to replace the ambient light sensor on my 2001 Chrysler Town & Country but I don't know where it's located, any help?

go to youtube
O2 Oxygen Sensor Replace on 2001 Town and Country
O2 Oxygen Sensor Replace on 2001 Town and Country

I know on my ford ranger the switch is located inside the door such that when the door latch rotates around the lock pin, it actuates the switch. If you don't see the switch in the door jamb, pull the inside door panel off and take a look around, focusing on the area around the latch.

NO Parts are ever replaced until all issues are properly
diagnosed,component tested & fail a test

You find the problems FIRST --- Then resolve them

Need a repair shop

Take it to autozone and they will diagnose it for free.

I do not have a diagram but, bank 1 is the bank where #1 cylinder is at. other side would be bank #2. so bank #1 o2 sensor is just before convertor.

the first one on the right hand side before the catalytic converter

depending on what size motor you have, the 2.4 has the sensor mounted on the rear of the cylinder head. the 3.3 & 3.8 engines have them mounted on top of the timing case cover, Good Luck!

like a gas pump? it means you need gas....

when its at -40 usually its because the ambient temp sensor is not sending the proper signal to the controller.. it may just be disconnected.. the sensor it behind the grille.. it has a 2 wire connector to it ... itf its connected it may havea broken wire from body damage in an accident... its rare that the sensor fails..

2001 Chrysler Town and Country- Won't start. Turn over. It acts like the fuel is not getting to the engine. After many attempts , it starts and runs like there are no problems. The car has 120,000 and has never had a problem. Is the fule pump bad?