2007 Nissan 350Z Logo

Related Topics:

Thomas Tankersley
Thomas Tankersley Posted on Aug 06, 2016
Be the first to answer

My 2007 350z rolled and hit a large curb. Heard grinding noise for a few days. Now wont start. Battery is fine. Ideas?

Answer This Question

2 Related Answers

omiga man

Alan Gowar

  • 452 Answers
  • Posted on Sep 03, 2012

SOURCE: 2001 nissan pathfinder- car wont start

Check tightness of the clamps on battery & make sure the earth cable is tight from battery to engine, also check tightness of nut holding the cable 2 starter motor if all ok there its most probably the solenoid on top of starter motor replace this with new all will b ok.

Ad

Don Cahala

  • 239 Answers
  • Posted on Dec 21, 2014

SOURCE: i hear a grinding noise when I attempt to start my maxima

Sounds like the starter is not meshing with the flywheel. New starter or new ring gear- maybe both if it's been going on for a while. Good luck!!

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
3answers

MY TURBO SUBARU IS RINNING FINE BUT UPON STARTUPS ITS MAKING LOUD GRINDING/TAPPING/WHINING NOISE.REPLACED STARTER MOTOR AND STILL HAVE NOISE AND CAR HAVING TROUBLE GETTING STARTED
Hope you have this fixed by now but sounds like a bad battery.
Read full answer
Aug 27, 2015 • 1999 Subaru Forester
1helpful
1answer

2010 G37 - battery was dead - jumped it off and drove it for twenty minutes. Next morning it wouldn't start and now it wont stop clicking (like a relay). Any suggestions?
if the battery goes dead or low it must be recharged with a charger, driving the car will not recharge it properly. The alternator is only meant to maintain the battery, not recharge it. Get the battery recharged and verified and then try again.
Read full answer
Mar 02, 2015 • 2010 Infiniti G37 Coupe
0helpful
1answer

2003 Mazda Mazda6 V6 Overheating + Grinding Noises
Is the serpentine belt still intact? The grinding noise maybe the water pump which would account for the overheating.
Read full answer
Feb 17, 2014 • Cars & Trucks
0helpful
1answer

Dash rubbing noise
No ideas at all
You may never solve that
But you know it wasn't there before
the curb issue.
Read full answer
Jul 24, 2013 • 2005 Ford Taurus
0helpful
1answer

2004 Chevy Tahoe - Driver side front tire - sounds like it is grinding when I lift the tire and spin the wheel by hand. This morning, leaving my house I heard a clunk noise. I immediately stopped a
This sounds like a CV joint is bad. It is binding up and locking and then slips when you move.
Read full answer
Mar 08, 2017 • 2004 Chevrolet Tahoe
0helpful
1answer

I have a kia sorento 2003 , it was snowing outside so i drove and i hit the curb .... the car it didnt have really gas in the car and i didnt heat the car .. so wen i hit the curb the car automatically...
may need the collision sensors reset..try this disconnect the battery negative with th e key in the run position, then shut everything off and reconnect the battery.. then turn the key to thr run position for a few seconds...this resets all the factory presets.. see if the car will start..repost findings...
Read full answer
Feb 09, 2013 • 2003 Kia Sorento
0helpful
1answer

Daughter hit a curb with a ford focus 2005 now the battery wont stay charged. Replaced battery all was fine started the next day. After driving the car died nothing worked got a jump and car ran like no...
1. Check all the cable connections on the battery and on the alternator.

2. If they are all fine then have the alternator checked because from what you have described it is not charging. The usual problem is worn brushes in the alternator.
Read full answer
Dec 22, 2012 • Cars & Trucks
0helpful
2answers

Car pulls right, terrible grinding noise from front right.
TAKE IT BACK WHERE THEY DONE THE LAST LOT OF WORK and tell them to do the complete job again as it sounds like a con job to me as a wheel aligment should last for a year a least and the grinding is in the braking system and something must still be bent ,
Its still under warranty dont pay any more..
Read full answer
Oct 26, 2009 • 1993 Buick Regal
6helpful
3answers

Grinding starter on my 1988 Ford Bronco II
the sound you hear is the starter grinding against broken teeth on the flywheel, for that to be repaired the flywheel on the vehicle will need to be replaced.

MIKESTA
Read full answer
May 11, 2009 • 1985 Ford Bronco II
1helpful
1answer

2002 Jaguar x-type
This may be as simple as some cells in your car battery being knocked out. Try a jumpstart and if this works then it is the battery.
Read full answer
Aug 20, 2008 • 2003 Jaguar X-Type
Not finding what you are looking for?

View Most Popular

2007 350Z

  • Cars & Trucks

Related Question

MY TURBO SUBARU IS RINNING FINE BUT UPON STARTUPS ITS MAKING LOUD GRINDING/TAPPING/WHINING NOISE.REPLACED STARTER MOTOR AND STILL HAVE NOISE AND CAR HAVING TROUBLE GETTING STARTED

  • 1999 Subaru Forester

Related Topics

84 views

Ask a Question

Usually answered in minutes!

Popular Questions

Airbag light keeps flashing

2004 Nissan 350Z

TCS/SLIP & Check Engine Light Warning

2003 Nissan 350Z

Convertible top sticks, will not fully open

2004 Nissan 350Z

2006 Nissan 350z convertible top sticks, will not fully open

2006 Nissan 350Z Roadster

2003 350Z window problem

2003 Nissan 350Z

Check Out the Latest Top Trucks Report!
Check Out the Latest Top Trucks Report!

View all Fixya Reports

Top Nissan Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

PDF Manual
. 2007 350Z Manual

2007 350Z

Loading...