Hotwiring fuel pump on 2001 ford expd which color is hot wire?

you stated pump kicks on put clutch in and no start so what would you hot wire [[and dont hotwire anything ]]]which causes more problems and in this case is probably pump not problem ----theirs a clutch safety to start in manual trans which that or ignition system problem such as failed starter --ignition switch --etc have vehicle for any possible trouble codes

Grey wire hot.Black wire ground.

Ford Windstar Fuel Pump Wiring Diagram Ricks Free Auto Repair Advice

dangerous not a good idea and a very very high liability factor if you get hurt you hurt someone or cause property damage

It doesn't work that way. If there is continuity through the inertia switch, both wires coming and going are hot.

I don't have the diagrams. Not buying it either. But it is either pink or grey. Anything black is ground. Since 99% of the ones I do is grey, I choose this one. A 94 has 4 wires. Two are ground. one is the fuel pump, the other is the fuel sender/gas gauge. Ground it , then add 12 volts to the others. It won't hurt it. If you won't the wiring schematics, Go to alldatadiy.com ad you can buy them, plus everything else about your car.

If I recall the color coding, that should connect to the fuel pump relay.

This I think is the yellow wire which is hooked to the starter relay and goes to the common contact of the fuel pump relay.

if the fuses and relays are good then have you check the dash switch,you may have to check the wiring(powers)from the pump back through the system until you find were you have lost power.

Check the wiring between the fuel pump and the wiring harness, this sounds like a short or wire melting to something hot.

There could be many issues. These codes read your engine is running too lean. Check : all your vacuum hoses for leaks, PCV valve and hose, MAF sensor. This may require an experienced technician to figure this out. Hopefully I help'd!!