Guage cluster panelnot working

i would recmend changing the cluster as you have changed the vss and it seems to have other issues with lighting up other needles in the cluster

several things could cause this, a connector on back of panel came loose, shorted wire rubbed through insulation. start with looking at gauge cluster panel.

youtube shows you how,, type in remove dash cluster

try checking fuses under dash and hood if good prob. ground wire

light bulbs for the backlighting of the guage cluster are usually on the same wire, so if there is only one of them out, it should just be that bulb is burnt out. you'll have to remove the trim panel around the guage cluster and the remove the guage cluster. there will be a bunch of bulbs on the back side of it, but approximate the location of it and visually inspect them until you find the one that is burnt out. replace it and reassemble

these cars have problems withe clusters. get a used cluster from the junkyard.

Unhook the battery hold the wires together for about 3 min, this should reset the cpu that runs the car. If that doesn't work check for a blown ground somewhere. Or you could have fried the guages, possible, but not likely. Don't forget to vote.

Not a Fuse. There are Small Bulbs on the Back of the Guage Cluster that Burn out Occassionally. You will need to Disassemle the Dash and Remove the Guage Cluster to get to these Mini-Bulbs for Replacement. Please Rate my Solution, I need all the Help that I can Get! Thanks!

well the issue is youe enitre gauge cluster i do understand that your speedometer is working but it is a cable speedometer not electronic like everything else in the gauge cluster so first i would recomend checking the voltage getting to your gauge cluster then just replace the guagecluster they are really cheap i a salvage and not hard to install at all but the cluster itself is not very comon to go out so make sure you check voltage to it first i wouldnt want you to go through buying and replaceing the cluster and that not fix it

does the cluster light up when your headlights are switched on? if not then iinput cable behind the cluster may have come loose you will have to take the dash apart to get the instrument panel off and get to the input wire.   If it does light up then you may have a loose connection and or a PCM problem which is the cars computer have your obd II codes checked at autozone.