DVD only goes to menu and stops

There is a key trunk access behind the drivers seat.
It's probably your battery. Even if your battery shows that it is close to 12v sitting, I've found that the amperage comes in to play when trying to start it.
Good luck,
Patrick

this is indication the Syscom has failded,see the diagram attached. You must go to the repair shop for fix it.
God bless you

Yep, its pretty easy, lower the screen down, your find 4 phillips screws, unscrew them, them the dvd will separate from the headrest. be careful not to tug on the wires too tight, push the button on the connectors to free them from the circuit board, label the white one goes on the left and red connector goes on the right. now you have the dvd free and can remove the screws on the back to free the cover on the front, the button should be stuck between there. have fun

simple test for a vacuum brake booster
star and run the engine at idle without applying the foot brake
if it gets worse when the foot brake is applied , it is a vacuum leak in the booster ( replace the booster )
otherwise check for failed vacuum hoses including under dash control lines , vacuum leak at the manifold or EGR unit

I had this problem. I read the manual and it states that if you remote start your car and then remote-stop the ignition twice, you must place the key in the ignition and start the vehicle once to reset it. I think it is to keep children (or anyone else) from playing with the key fob and playing the start-stop-start-stop-start-stop game! Hope this helped!

Hi,

1. Insert your key and turn the ignition to "Acc." Don't start the engine.
2. Push and hold down the "Disp" button on the radio. Release the button when the radio shows "Settings."
   
3. Press "Seek Up" repeatedly to toggle through the menu. Stop when the screen shows "Fob Prog."
4. Press "Next" and make sure you have your remote handy. Press "Disp" to begin the programming sequence.
5. Push and hold down "Unlock" and "Lock" together on the remote as soon as the screen shows "Push Fob." Hold the buttons down until you hear a chime.
6. Press "Seek Up" until your see "Exit." Press "Disp" to exit the menu.
7. Repeat these steps for any additional remotes that you wish to program

Best regards

Where you ever able to get an answer to this? My husband and I just bought this van and are having the same issue! Please help if you have solved this issue. Thanks

Either wire harness problems or you got a so called lemon
One of the first books of Ralph Nader about auto industry.

Had a Hyundai like that 27 years ago. Until I took it totally apart and re-assembled it myself. 2 years ago bought a Piaggio 45 cc motorbike, same story. Took that apart one night and put it together as should be.

I have a 2007 montana sv6 and want to put a factory dvd player out of a 2006 montana in my 2007 my question is are the wires in the roof from factory and were do I cut the head liner