What tools are needed to change back breaks on kia rio 2002

put fuse back in disconnect batt wait 60 seconds re attach, when the horn starts honking lock and unlock drivers door with the key while doors closed window down. get in car and start it, should be fine now.

Your standard spark plug socket size is a 5/8. Make sure that you buy one that is used for spark plug removal, these have a special rubber boot on the inside so that you don't accidently break the old plugs in half. Any auto parts store sells this socket.

You can use DOT 3 or DOT 4..Either one is fine to use as they can be mixed. DOT 4 will have a higher boiling point.

Front brakes would cost aprox: $180 or less for rotors+pads for the front. If you do it yourself. Hope this helps!

The o2 sensor is located in the exhaust pipe. follow the exhaust down under the engine until you see a short cylinder with a nut shaped end sticking out, It will have a wire sticking out of it . The sensor will not point at the ground but up where no road debris would break if off. You wll need a special O2 sensor tool to remove it,about $15 or can be borrowed from some auto parts stores

you will need a pry bar it will snap out with a little force,I hope this helps you and thank you

yes, this is VERY IMPORTANT, this is an interference engine, meaning the valves and the piston cannot be in the same place at the same time,or it will bend the valves.then you are looking at a major repair job,think or it as insurance on your engine. please rate my fix as i strive to be the best,questions,get back to me

how to change clutch cable kia rio 2004

can anyone tell me how to change the time belt on my kia rio cinco

It's a korean piece of ****...when the timing belt breaks or slips, the engine just stops...only after it has bent a piston, rod, or blown a headgasket...all without warning.