Where is the transmission dipstick for a mazda 323 protege 2000 model

SOURCE: Locating oil filter on 2000 Mazda Protege

on the backside of the motor, towards the firewall. look above the drive shaft. it's about haft way up the motor.

Harvey N Tawatao

• 3854 Answers
• Posted on Nov 16, 2009

SOURCE: where's the transmission dipstick on a 2000 saturn sl

The Saturn L series automatic transmissions do not have a dipstick. They are the "new breed" of transmissions that are SUPPOSED to be trouble free. There is a plug on the passenger side of the transmission by the drive axle It is 11mm bolt. start the vehicle in park on a level surface or hoist...at operating temp pull out the plug Fluid should just trickle out of the plug hole If no fluid comes out add fluid to trans until it does...Where do you add??? Red plug on top/center of trans. Plastic plugthat threads in Add fluid there....Good luck

SOURCE: how to replace a timing belt on a 2000 Mazda Protege

Here is a website that a free manual can be down loaded for your vehicle


http://ezinearticles.com/?Find-the-Free-Auto-Repair-Manual-You-Need-Online&id=92717

SOURCE: Owner's manual for Mazda 1995 car 323 - auto

autozone.com sign up its free then click on repair manuals you will find all of your info there....good luck

SOURCE: Place to check and fill Transmission oil in Mazda Protege 1993

Don't listen to the other guy, I own a 1990 1.8L mazda protege with a manual transmission. Yes it will make it easier to hoist it up. I am not going into extreme detail so as long as you know a little about cars this will be a great help.
on the transmission locate the drain plug, it will be on the bottom of the transmission. don't loosen it yet you want to make sure you can fill the transmission before you drain it. there is no fill plug, you have to fill the transmission through the hole the speedometre cable is attached to the transmission. the speedometre cable is straight up and down/vertical, it should be above the passenger side cv shaft coming out of the transmission.
remove the small bolt holding it in place and then pull it straight up and out of the transmission. now drain the transmission. put the drain plug back in and start filling, make sure not to overfill you are not supposed to fill it right full.
Make sure to check the fluid level as you fill, the transmission is at the right level when the gear oil is just at the top of the speedometre gear that is on the end of the cable that is inserted into the transmission.
I believe these transmissions take 75w 90.
Hope this helped you, and maybe future people who view this looking for help.