The 3020B just shows a quetion mark on the screen

Question edited for clarity.

ABS code

Code 61-1 and 62-1; ABS Battery Voltage High Malfunction

https://www.elementownersclub.com > threads > code-6...
Sept 18, 2016 - Having recently purchased an 06 Element, I'm in the process of going through everything. When I bought it the airbag light was on and ...

abs code 61-01 - Honda Civic Forum

https://www.civicforums.com > ... > Brakes
Brakes - abs code 61-01 - My 07 civic EX is vibrating, at startup and idle, definately coming from right front . Vibration diminishes with RPMS.
Missing: 3020b, ‎' Must include: 3020b,

Support - Code Library - Innova

https://www.innova.com > pages > dtc-library
Enter your vehicle's make and the diagnostic trouble code shown on your innova tool to find out manufacturer specific information about the code being displayed ...
Missing: 61-01 ‎' Must include: 61-01

• 
  

  Manual_3020a_E.pdf - Innova

  https://csr.innova.com > Content > Manual > Man...
  PDF
  This manual describes common test procedures used by experienced service technicians. Many test procedures require precautions to avoid.

The models of the two cars are different, and the codes should also be different. Kijang Innova can only read its own code.

Those codes don't match the year of the car for the ecm that should be in it.

The scanner check procedure for Innova or Innova venturer is as follows:
(1) Turn the ignition switch to OFF (disconnected);
(2) Plug the scanner power cord into the cigarette lighter holder;
(3) Connect the scanner to the diagnostic communication circuit or the diagnostic socket of the check connector;
(4) Turn on the ignition switch; start the scanner to check the fault code;
(5) Turn off the ignition switch for troubleshooting and analysis, then turn on the ignition switch, and use the scanner to erase the stored fault code;
(6) Take off the scanner.

obvious quetion , sorry , have you had the tyre inspected for condition etc , even balance

are you sure that you have the plugs in the right firing order?

Sorry not spicfic enough to answer this quetion engine size and codes would be most helpful thank you

disconnect ignition power ... pull all your spark plugs and check for compression. quetions write back

honestly your best bet would to be installing the side skirts with pop-rivets. Get a manual pop riveter. You can purcjase this at any local hardware store, also you will need to purchase some pop rivets. Ask a sales associate what sise you will need, by telling them what you are riveting they should be able to help you find the right size and length.Start by marking exactly where your side skirts will be on the car. Make sure to align the skirts perfectly in mock up so you wont run into any issues with the door rubbing against the newly installed part. mark your holes for where you want to put the rivets placing one every 9 inches to a foot apart. You may also use fewer or more rivets it all depends on how secure you feel with your work. Next after all your holes have been marked drill holes in the spots that you have marked, this will allow you to lign your side skirt back up and mark the frame. Once the frame is marked you will need to drill the marked holes out. Be sure that the drill bit you use does not exceed the size of the stud on your rivet. This will cause the shield to seat wrong and make it that much easier to putt out of the frame. Finally after all your holes are drilled install your rivets and break off the studs. You should be good to go. Word of advice if your car is allready paintes and your side skirts arent, but you are planning to paint them after installation, DONT! drinn your holes in the kis sand any rough edges down and paint it will save you time and hassle in the long run trust me! hopes this helped