Warning Messages
The warning messages can interrupt the display until cleared or reset by the driver. The warning messages are either single cycle, non-resettable, or repetitive warning messages.
The single cycle warning messages display once whenever the ignition switch is turned to the ON position or a fault occurs in a system, and can be cleared by pressing the RESET button. The single cycle warning messages are:
SOURCE: 2005 toyota camry 4cylinder
disconnect the positive battery cable for 3 min.reconnect and start it up,if light comes back on,there is a malfunction in computer system that controls your drivetrain.service engine soon light pertains to the computer,sensors,etc.this light is not for maintenance reminders!
SOURCE: Remove Oil maintenance required message on 2008 Toyota Highlander
This is the reset proceedure for a 2008 Highlander with a key-type ignition:
Turn the key ON, do not start the engine.
Look at the odometer, and verify that it displays "TRIP A". If it is on "ODO" or "Trip B", press the black stick next to the odometer to read "TRIP A".
Turn the key OFF.
Press in, and HOLD the black trip meter reset button, hold it IN.
DO not release it.
Turn the key ON, do not start the engine
Observe the Odometer display. You will see 5 dashes, then 4, then 3, then 2, then 1 dash, and finally, 5 zeros. Then, whatever number that was displayed on "TRIP A" will be re-displayed..
Now release the black trip meter reset stick.
This completes the reset procedure, and it will be back on in 5,000 miles, to remind you of you next oil change.
Hope this helps! Thanks for choosing FixYa!
SOURCE: Service emission sys warning message on ford Mercury Mariner 4DW 2005
Injector Cleaner is not in any owners manual
It is a few onces in many gallons of gas & does nothing
Check for codes & have the car diagnosed --as with any and
all issue from the past on any vehicle
If you over fill it you can get fuel into the evap canister
2,363 views
Usually answered in minutes!
×