SOURCE: Harmonic balancer
Check out this link: http://www.autozone.com/addVehicleId,1602402/initialAction,repairGuide/shopping/repairGuide.htm?pageId=0900c152800cc1e1. This is for a 6 cylinder in your year. This gives you the specs for all of the bolts associated with the crankshaft damper. Good Luck!
SOURCE: 95 buick lesabre crankshaft pulley removal
i had used three bolts they have to be 6mm thik and like about 6 inches long then you install some flat washers by the head and use a regular crank pulley remover, you'll see three little holes inside the groevs at front side of pulley and there is where you install the bolts
SOURCE: how to remove the crankshaft harmonic balancer on
National fine thread, regular right hand. You may need a puller to remove damper after removing bolt.
SOURCE: I need to know what size wrenches are needed to
you will need sockets,the crank bolt i belive is 22mm and you might need in impact wrench to remove bolt. the crank sensor is 1/2 in or 13mm, that a rachet is good.and to remove balancer sometimes youll need a puller. hope this helps.
SOURCE: How can I stop the crankshaft from turning so I
The easiest way is to remove the inspection cover at the rear of the engine where the transmission bolts on and slide a screw driver or chisel in the teeth of the ring gear and let it come up on the block. You may need a helper to hold it unless you can find a way to keep it in place while you torque. Hope this helps.
Testimonial: "Thanks for your FAST reply! Looks like I'm gonna get this old heap on the road today after all! Mahalo Nui Loa! Ken"
90 views
Usually answered in minutes!
×