SOURCE: Driving a 2003 Ford windstar. Went to pass and
Very common on this make and model trans, pump drive splines inside torque converter strip out and pump is not turning, Most times there is no damage to pump shaft. Remove trans and remove torque converter, inspect the splines at the very bottom of the hub hole. If stripped out inspected pump shaft splines which are the smaller center splines coming out of trans, if ok replace torque converter and re-install trans, change out fluid, clean any metal from magnet and replace filter, fill with fluid and verify proper operation.
SOURCE: 2002 Windstar wont go into gear
These are common for the pump shaft splines stripping in the torque converter. The transmission will need to be removed to fix it. Before you condemn the trans, does the speedo move and the van doesn't or do you hear any grinding when you put it back into park? Or can you push the van in park (Broken CV shafts)?
SOURCE: 2000 ford windstar problem with gas mileage
Start the car with the hood open. Check the engine compartment as well as the fuel line from the fuel tank to the engine compartment. If there is a leak you will find it. Remember gasoline will evaporate quickly when there is air movement so watch carefully to make sure you don't look over the leak.
SOURCE: can i put a 1999
First Get both Vin Numbers
Second Take Vin Numbers to yur Local Parts Person and have them check to make sure nothing has changed in those years. Some times their are up dates , or sometimes the company made changes and then if they did changes , than no it would not work.
49 views
Usually answered in minutes!
×