1996 saab 900 s changed backup bulbs and license plate bulbs and they still don't work....any ideas?

Which fuse belong to license plate light or which number ...

www.fixya.com/cars/t10801433-fuse_belong_license_plate_light_or

Nov 11, 2011 - The licence plate lights are in the same line as your tail light wiring assembly. I assume your ... Previous owner cut wires going to lights for license plate. ... 1996 ford explorer license plate fuse ... 09@1998 ford f150 fuse box.

1997 Ford license plate lights are not working. - Ford Explorer ...

www.explorerforum.com > ... > Performance Lighting

Mar 13, 2011 - 5 posts - ‎4 authors
can anyone tell me why my lights would not be working on my license plate, i replaced old bulbs with new bulbs and checked every fuse and ... Parking lights stay on
19 posts
Sep 5, 2012
my tail lights wont work, and im out of ideas. i need help ...
18 posts
Sep 15, 2011
License Plate Lights
11 posts
Mar 24, 2011
trailer light problem
15 posts
Apr 22, 2009
More results from www.explorerforum.com

Check wiring connections

It just means your Throttle Position Sensor is out of Self-Test Range. This is usually because your throttle linkage might be bent or binding or the throttle plate is not closing correctly. If the car runs and idles fine, I don't think it's anything to worry about. It may be that the sensor itself is not functioning properly.

With the age of the car it could be that your grounds are bad somewhere which explains why essentially no lights work ... even though the bulbs/fuses are OK. You get power to these lights by having positive wires going to the light bulbs and the negative side of the circuit coming from the frame of the vehicle (referred to as the ground).
Pull all the connectors that you can see and make sure they are not corroded.
Check also that no associated relay that has anything to do with the rear lighting is not bad.

did you replace the bulb? is the the question? or is it still not working if you did that?

1996 SAAB 900 SE Brakelight Failure SID info
- stalls in reverse etc.

The problem lies with the grounding point in the left rear body cavity on the floor, see the diagram.
Rust eventually destorys the ground and the car will not run in reverse nor do the backup lignts or the rear hatch defroster work amongst other things
Re-attach the grounding wire to an existing welded stud on the side body panel and the problem is solved.

yes it the ab relay in the aft end

remove the light pannel and check the sockets for corrosion and the trunk release should be in the glove box

License Plate Lights Removal & Installation 1997 – 2000 To Remove:

License/backup Lamp Assembly

1. Remove the rear compartment lid trim. (if necessary)
2. Disconnect the license/backup assembly connector from the body harness.
3. While removing the license/backup lamp assembly from the rear compartment lid, disconnect the harness grommet from the rear compartment lid.
4. Remove the license lamp housing from the license/backup lamp assembly.
5. Remove the license lamp bulb from the housing and socket.

To Install:

1. Install the license lamp bulb into the socket and housing.
2. Install the license lamp housing onto the license/backup lamp assembly
   • Torque the fastener to 18 in-lb (2 Nm).
3. While holding the license/backup lamp assembly, install the harness grommet to the rear compartment lid.
4. Install the license/backup lamp assembly
   • Torque the fasteners to 53 in-lb (6 Nm).
5. Connect the license/backup assembly connector to the body harness.
6. Install the rear compartment lid trim. (if necessary)