SOURCE: Need serpentine belt diagram for 2002 Pontaic Sunfire
CLICK HERE
Thanks for using FixYa - a FixYa rating is appreciated for answering your FREE question.
SOURCE: diagram for under hood fuse box
YOUR FUSE BOX UNDER THE HOOD IS LOCATED BESIDE THE BATTERY RIGHT SIDE THAT IS AWAY FROM THEWINDSHEILD, ITS A BLACK BOX RECTANGLE SHAPE IT HAS A COVER OVER IT SNAP THE COVER OFF AND YOU WILL SEE THE FUSES
SOURCE: I NEED A DIAGRAM OF THE FUSEBOX AND RELAY BOXES
On the cover of the fuse box indictes what each fuse/relay controls
SOURCE: under hood fuse diagram
i have a missing fuse in the under hood fuse block and in my manuel the space there reads a i r
SOURCE: Where is the starter located
I replaced the starter on my daughters 2002 lancer and did it the hard way by crawling under the car to figure out where it was first, and then working underneath to get it out. After performing the procedure I realized there is a much easier way to do it.
- The starter is located on the back side of the engine under the intake manifold towards the drivers side of center. It is very difficult to see from the top with everything still assembled.
Replacing the easy way:
1. Disconnect negative battery cable.
2. Remove the plastic air filter box first. After it is off you can easily see the starter down by the shifter linkage bracket.
3. Remove two bolds holding the shifter linkage bracket so it can be moved out of the way.
4. Remove wiring connectors from back of starter solenoid. One connector is just a slide on, the other main wire is held on by a metric nut. That one may look impossible to get at, but if you configure a 1/4 drive ratchet with the right sized deep well socket you have room to work it through a cut out in large mounting bracket that you will see below. I'm thinking the Japanese engineers put the cut out there for this purpose.
5. Remove two starter mounting bolts and allow the starter to slide down and back so as to rest on the bracket below.
6. Walk around to the passenger side of engine and reach down under intake manifold to pull starter up and out.
7. Reverse procedure to reassemble.
8. Done without ever crawling under the car!
102 views
Usually answered in minutes!
Hi Carol hudson, I want to help you with your question, but I need more information from you. Can you please add details in the comment box?
Where do i spray to clean my intake valves without taking off heads on 2002 eclipse spyder 2.4L 16 valve non turbo
×