Take the globe out and the light will go out
SOURCE: transmission
I had that problem in my 1998 Blazer. There is a module on the passenger side of the truck, next to where the passenger right foot be. Remove the side kick panel to get to module. Disconnect battery before unpluging and pluging new mudule in. This unit controls the electronic switching between 2 and 4 wheel drive..Wes
SOURCE: 2000 Ford Expedition wont start
On the engine there is a tube that supplies fuel to the fuel injectors, on that tube there is a valve, like a metal tire valve, this is the fuel pressure test port, you will need a special guage to check the pressure that screws onto that valve, Kragen and other parts stores sell this test kit, it is very inexpensive, about $20.00, but cheaper than having a shop do it for you, if you do the test and you have no pressure while cranking the engine then your fuel pump is bad, the pump is in the gas tank, a big job and dangerous due to chance of fire if you are not cautious.
SOURCE: 2003 ford expedition "door ajar" & interior lights staying on
the wire on the door latch make sure they are plugged in or unplug it and the light should go out if it does not then it's not that door
SOURCE: stuck in 4 wheel drive and wont come out.
hey there i cant tell you what you are missing but i can tell you how to disengage the front wheels . ok you have a vacum line that runs right under the battery and a line that comes up from the front diff. to the same place ( you may have to remove batt and batt tray to get full access to this) un bolt it and temporaly put batt and batt tray back in start it up and decompress this and see if it comes out .... you should here clunking noise if it goes back in ... if thats the case just pull that big vaccum line off .... to test get all four tires off the ground and have some one put it in drive but dont hit the gas it should turn on its own ...if that dont work check the cable that runs down to the differental
SOURCE: What would cause my 4x4 light to stay on yet not
stuck 4x4 sensor?? just disconnect the wire. you will get the picture mate..
66 views
Usually answered in minutes!
×