Usually Kurt there will be a bracket on the tube that secures it to the engine block. Undo the fastener that secures the tube and gently pull upwards while rotating the tube out of it's press fitting. To install a new tube or when replacing the old one...select a box wrench that is just a little bigger than the tube diameter and slide it down to the bottom of the tube until it is pressing against the seating flange. Make sure the alignment of the bracket is close to where you want it to be and then gently tap on the edge of the box wrench to seat the tube. A long handled screw driver helps in tight quarters. Secure with fastener.
159 views
Usually answered in minutes!
×