On 84 porsche 944 can the flywheel be spin around to ot without the camshaft spining since the camshaft is set to tdc.

The next step to what?

Great question but this is the wrong category, go to car audio category.

I suggest you raise all your 944 questions on one of the specialty Porsche forums like this one below but there are others...


Porsche 924 944 968 Technical Forum Pelican Parts Technical BBS

yes, turning ignition on powers the fuel pump--its electric

LOOK TO ALIGN THE MARKS OF THE ENGINE TO TDC. WHAT DO YOU MEAN BY TORQUE TUBE?

I would say yes, but not a good idea. The heat shield is there for a reason.

5

5 is 3 TDC like any cheep VW engine

http://www.bing.com/videos/search?q=84%20porsche%20944.%20install%20engine%20&qs=n&form=QBVR&pq=84%20porsche%20944.%20install%20engine%20&sc=0-0&sp=-1&sk=


84 porsche 944 install engine Bing Videos

on the top of your crank shaft behind the small plate and your bottom of flywheel remove front cover and turn engine over and you see the diamond mark on the crank and you should see the markings on the flywheel where the crank sensors are plus the marking point on the bottom of the clutch housing if all three ar line up properly youe timing should be good plus make sure your balance shaft roller are set also?

check your air filter sounds like it is starved for air possibly