3 possibilities. Bad oil sending unit. Bad crank bearings. So much sludge in the engine that the oil can't get back to the oil pan fast enough, this will cause bad crank bearings. I would pull a rocker arm cover first. If it is full of sludge, put it back on and drive it till it dies. save money for another car. If it is clean, replace the oil sending sensor.
Check oil level on dipstick and if low add quart
SOURCE: Why does the brake light indicator turn on occasionally?
the switch on the parking brake is defective
SOURCE: oil pressure light at low RPM
Before you have major repair done on your car because of the "oil pressure light", review the list and see if any of these might be the source. Some of the things on this list are things you can do yourself, some only done by a mechanic (inexpensively), and others require the aid of a mechanic.
1. Check to see if you have a leak. Low oil levels can make the oil sensor light come one. Check your oil level following the manufacturers recommended procedure or use the information listed here http://autorepair.about.com/od/regularmaintenance/a/checkoil.htm. If you do not have a low oil level, but still suspect a leak, place a drip pan under the oil plug overnight. If you have a leak, you'll see signs of it there. Then take the vehicle to a trustworthy mechanic and let them trace the leak. It is possible for your engine to only leak when it is hot, so make sure you get the engine nice and warm before you put the car away for the evening and place the drip pan under your vehicle. Other signs of an oil leak are listed below as well as an "oily" exhaust that leaves it mark on your bumper or "blue smoke" as you drive/idle.
2. Check the coolant levels. If the coolant is low, the oil will heat up faster and cause a viscosity breakdown. When the oil viscosity is low (= thin oil), the oil sensor light can come on. If the coolant is low, add more. Keep in mind that an engine running hot will heat the engine oil to the point that it thins out and burns off in the cylinders. If the coolant level is fine, have the coolant (water) pump checked. If the coolant is not circulating well through the engine, you'll probably have coolant boiling over, too.
3. If you can afford to do it, change your oil to a higher or lower viscosity. Refer to your maintenance manual and your trusted mechanic. I say this because, if your oil is thinning out too much because the viscosity is too low, your "check oil" light will come on. If your engine oil is too thick, you engine will need added internal pressure to get it to circulate. At lower RPM (just like thin oil), your engine oil light will come one.
4. Have the oil pressure checked by other than an electronic means. Your trusted mechanic can place an oil gage between your oil filter and the rest of the engine or on the oil fill cap of the engine. If you are having an oil pressure problem that is seal-related, that should narrow it down. If you can't afford to do that, when you get your next oil change, replace: the oil fill cap, PCV valve, and air filter. All these contribute to the measurement of engine oil pressure by that picky little oil pressure sensor.
5. Have the oil pressure sensor checked. You may need some weird add-on to make it behave. Do a search for the following part and read and you should have a better understanding: "part # 05017800AA a terminal/wire/vent to the oil pressure switch connector". Never forget that sensor are usually engineered to report a problem well before a catastrophic failure can occur.
6. If you're driving a high-milege car, make sure you are up to date on all of the engine-specific services. For some vehicles, it is recommended that the head gaskets are replaced. If you have internal engine leaks because of it, this will solve most of those issues. Signs of this include: coolant visible in the crankshaft area (you can see this with the oil cap off), oil fouling your coolant (you can see this in the coolant reservoir), or smokey exhaust. Expect your trusted mechanic to recommend that you change your spark plugs, timing belt, and cam shaft gasket at the same time.
7. See if the oil pump needs to be replaced. A faulty oil pump can contribute to low oil pressure as it fails (but hasn't failed, yet).
8. Do all of the above BEFORE you take to recommendation to have your engine replaced.
I have a 1998 Chrysler Cirrus (I know it's not a minivan, but hear me out). I've been the single owner and have learned more about how engineering oversights or over-cautiousness can send you to the mechanic for just about everything.
Hope this helps!
SOURCE: 2000 Dodge Caravan - Air bag light comes on.
This is a signal of a bad abs sensor. replace the abs sensor asap.
SOURCE: What is the sequence for the bolts on oil pan, for
For the 2.8L there is no sequence. Torque for the bolts are 105 in.lbs.
For the 3.0L torque is 50 in.lbs. in sequence:
For the 3.3L and the 3.8L, no sequence but torque each bolt to 105 in.lbs.
Please don't forget to rate!
SOURCE: 98 Dodge Caravan Oil Light/Alarm comes on
Remove, check and replace the Oil Pressure Sensor. It should be located adjacent (just left of) the oil filter.
72 views
Usually answered in minutes!
×