SOURCE: brake pad replacment on 2004 Dodge Ram 1500
Remove two bolts holding caliper on and pull up as hard as you can on the caliper. Wiggling back and forth at the same time helps.
SOURCE: thermostat in 2001 dodge ram 1500
the thermostat is located where the upper radator hose comes off the engine there are two bolts or nuts remove hose and remove housing you will see the thermostat when you do clean old gasket material off block and reverse removal procedure
SOURCE: check engine light on code
This trouble code is Evap Purge System Performance fault. 1) Check for a loose or missing fuel cap. 2) Check for a damaged or missing fuel cap seal. Recheck for other trouble codes. This fault wont cause the stumblering problem. It turns on the MIL lamp to say there leak in the EVAP system.
SOURCE: firing order for dodge 2001 ram van 1500,
Here you go:
5.2L and 5.9L engines Firing order: 1–8–4–3–6–5–7–2 Distributor rotation: Clockwise
Diagram link below:
http://www.chiltonlibrary.com/content/images/7924/images/79243g14.gif
Best of luck!
Greg
SOURCE: ignition switch removal and replace how to on
lock and tumbler (key switch) remove steering wheel remove clockspring remove set screw remove switch...lower column ignition switch remove 2 screws and the rod unplug from harness replace in reverse just watch the rod placement
311 views
Usually answered in minutes!
×