Installed new hinge pins on driver's side door. Keyless unlock/lock wont work and unlock button on door wont work what can we check?

Hi Charles

The drivers side door gets the most use
Check the actuator wiring coming through the door hinge
If it works from the key then the Power to the door is OK & the key switch is ok. Must be trigger wire from wireless device receiver!

Good Luck

Hyundai Door Lock Actuator eBay

Hyundai Entourage Alarms Remote Car Starters Keyless Entry Locks

First I suggest check and re-check wires and harnesses connections at/from door lock switches at/from drivers side, some loss or harnesses connections sometimes make this wrong.

If, before this replacement your locks system was working fine, a bad installation could damage this and other components. This could be the answer at intermitent keyless work, or your secuirty entry module is advice go to bad. There isn't way to test this, try re-sunchronized the keys according with your Owners Manual procedure o just will reprogramming with the dealer tools.

Hope this helps.

Could be very simple. Remove inside door panel & check for disconnected wire to solenoid. If okay--check where wires enter the door for broken or corroded wire & repair.

Hi.

To program ( or reprogram ) a keyless entry remote transmitter into the remote keyless entry module, perform the following steps:

1. Turn the key to ON or ACC and short the two terminals of the program connector, a two-pin connector located below the driver's side of the instrument panel at the base of the steering column. All doors should lock and then unlock.
2. Press any button on each keyless entry remote transmitter in turn. All doors should lock and then unlock. If the door locks do not respond, press the button again (up to three times maximum with the same keyless entry remote transmitter). If the door locks still fail to respond, go to Pinpoint Test A.
3. Repeat Step 2 to program additional keyless entry remote transmitters into the remote keyless entry module (up to four keyless entry remote transmitters maximum).
4. Turn key off.
5. Remove the short from the program connector. All doors should lock and then unlock.
6. Verify that the keyless entry remote transmitters have been successfully programmed by pressing the LOCK or UNLOCK button on each one, and observing that the system responds by locking and/or unlocking the doors.


I hope this helps you.

Thanks!

drivers central door locking module is kaput and needs flinging as far as you can then replace it with a new one or a salvaged one

lock actuator is bad...

It needs reprogramming. Contact Honda.

Good luck.

Rate this please

been there ------open up the rubber connector between the drivers door and the body [by the door hinges ] the wires break from flexing. just solder or **** connector them back together. it helps to add some wire to one of the broken ends to make it easier to connect . there may be more than 1 wire broken

https://northcoastkeyless.com/1997-oldsmobile-bravada-keyless-entry-remote-programming-instructions/

Do you have he owners manual? instructions are in there for the keyless entry system. If not go to this link:

http://www.motorcraftservice.com/pubs/content/~WOTEXP/~MUS~LEN/41/96expog1e.pdf