Yesterday i was installing a power outlet in the car & routed the wires thru the firewall where the speedo cable passes thru. the only thing i could think of is that i somehow pulled the speedo cable loose from the back of the instrument cluster.
You may have drilled thru firewall and cut a wire. Look very closely. Thank you and please leave feedback
SOURCE: code c1277 (steering angle sensor)
this vehicle uses a steering control module and the antilock control module. Both modules get a signal from the steering angle sensor. We found that the steering module didnot show a steering sensor code but the ABS module did show the code.
after checking that the wiring was intact and with good continuity, it was determined that the fault lies in the ABS module.
A new ABS module and configuration confirmed the diagnosis. It's fixed!
SOURCE: Not starting
did you install the battery backwards?if so,you might have caused some serious issues
SOURCE: Mazda 929 (92) airbag light flashes
take to dealership air bags detect a problem.it will have to tested and reset at dealership.
SOURCE: HOLD LIGHT FLASHING ON DASH PANEL
There's most likely an issue with your transmission. Bring it to a shop to have it scanned for any codes
SOURCE: I have a 94 Mazda MX-6 2.5 DOHC I was driving on
The timing belt has broken. Fortunately though, according to my catalog, this is not an interference engine and the engine should not be damaged internally.
252 views
Usually answered in minutes!
×