Mazda 323/MX-3/626/MX-6/Millenia/Protégé 1990-1998 Repair Guide1994 Mazda MX-6 2.0L MFI DOHC 4cylCircuit Braker
A bimetal circuit breaker is located in the joint box, which is just
above the interior fuse panel. This circuit breaker protects the rear
window defrost circuit and is the plug-in type.
Fuses
The main fuse block is located inside the left side of the engine
compartment near the battery. There is also an interior fuse panel
located just above the left side kick panel.
Fuses Replacement
CAUTION
Never replace a blown fuse with one of a higher rating. Severe
damage to the vehicle, electrical harness and components, as well as
personal injury or even death could occur.
Main Fuse Block(see Figure 1)
-
Disconnect the negative battery cable.
Fig. 1: Remove the fuse box cover, located in the engine compartment, to access the main fuses for the vehicle
-
Unhook the lock tab from the main fuse block cover and open the cover.
-
Pull the fuse from the main fuse holder.
-
Installation is the reverse of the removal procedure.
Interior Fuse PanelThe interior fuses simply unplug
from the fuse panel. Use the fuse puller tool provided with your car to
remove fuses from the panel. The tool is located on the back of the
interior fuse panel cover.
Relay
The main relay box is located on the upper left-hand side of the
firewall (bulkhead). There is also a relay box mounted inside the
vehicle under the left side of the instrument panel.
Relay Replacement
- Disconnect the negative battery cable.
-
If replacing a relay at the main relay box, disconnect the electrical connector and slide the relay from its mounting bracket.
-
If replacing a relay at the interior relay box, simply unplug the relay.
-
Installation is the reverse of the removal procedure.
Fig. 1: Typical fuse box and panel locations and configurationsI hope help you with this (remember rated this help) Good luck.
×