How can I enter radio code?

You may have entered the wrong code, disconnect the battery for a minute or so and try again.

unhook the battery for an hour or so to fully clear any previously bad entry attempts. hook battery back up and try the code again

Hi,
Probably has a security code. It's in the owner's manual or you'll have to take it to the dealer.

GL,
td

If you entered the incorrect code several times you may have ruined your chances of getting radio to work. On vehicles with anti theft radio when the battery is disconnected or the vehicle looses power the radio licks and to enable it a code is needed. The dealer may be able to help you but they would need certain information. Sometimes the vin of the car or some times the radio has to be removed to get the serial number. But if the wrong code is entered after so many attempts the radio becomes completely disable. To the point where you will not be prompted to enter a code.

Your radio is in theft lockout, you need the security code that came with the owners paperwork new.

When you disconnect your battery or remove the fuse and then reconnect itagain, it disables the radio. This is an anti-theft protection for your carradio.
The enable your radio the activation code is in your vehicle owner's manual. Ifyou do not have this code you need to go to your vehicle manufacrurers service centre andget them to enter this code for you.

It should be a numerical code. Just punch it in on the radio using the programmed station buttons. It won't give you any indication that you're entering the code, but when you put it in, the radio will 'unlock'

When the battery was down or removed the radio was reset and since this is done for secuirty the codes must be entered on the panel for the radio to be active. Please check the manuals for the codes or call your dealerships.
If not try the link below:

http://www.radio-code.com/

http://www.floodle.net/extra/ebayinfo/car_radio_decode.html

You can get the code from the dealer with the VIN# and you have to pull the radio out to get the radio's serial number. If you've tried too many wrong codes the screen will show error message. If so - disconect the battery for about 60 minutes to clear error message then reconnect and enter correct code

You are in luck.
There are no security codes in your radio.
Nothing to worry about when you change the 12 v battery.

Thanks for choosing FixYa for assistance!