Where is the oil pressure sensor located on a 2014 Dodge Charger SE

Look on the bottom front of the engine for a 1 or 2 wire cable.

The oil pressure sensor (2) is located on the oil filter housing (3). The oil pressure sensor is a three wire sensor with a tapered threaded sensor port. The sensor port is mounted to the oil filter housing through an access hole. A thread lock patch seals the oil pressure sensor to the oil filter housing.

The repair procedure says you need to remove the upper and lower intake manifold. It says the sensor converts pressure to a voltage. "The zero pressure reading is 0.5 volt and full scale is 4.5 volt." You might want to check the wires and grounds before going to all the trouble to replace the sensor

How-to remove shifter knob from a 2008-2014 Dodge ...

? 3:14
https://www.youtube.com/watch?v=D72UFkxVSuY
Sep 24, 2014 - Uploaded by jghdez89
How-to remove shifter knob from a 2008-2014 Dodge Challenger ... 75 Cent Mod, 2012 Dodge Charger R/T ...

shifter knob change - YouTube

? 0:38
https://www.youtube.com/watch?v=qp0dtS5gm9Q
May 9, 2008 - Uploaded by promise383
s/v/c70 and s/v40 auto shifter change. ... How to replaceautomatic shifter with any knob and boot you want. - Duration: 6:12. Greg Green ...

2013 GC SE - Shifter Knob Remo

Doubtful, trace wires from speakers using test light, does new amp have coaxial connectors? you may have incompatible model, probably need to match amp with new head unit, worst case you can rewire speakers directly to amp, use new wires, leave old wires in place just cut ends and put tape over.

The oil light comes on when the car shuts off because there is no oil pressure. Make sure it has oil in it. If so take the car and get the codes pulled off the obd computer.

Dear Anonymous
p0520 -engine oil pressure sensor circuit
you need check oil pressure wires and sensor part
what is oil use it in your car and how many KM you did
if your charger V8 you need use 5W20
if V6 use 10W30

It's behind the AC compressor.

Here is a website with pictures: http://dodgeforum.com/forum/dodge-caliber/340818-oil-pressure-sensor-location.html

Either low oil pressure or oil pressure monitor problem. You can screw a after market mechanical gage in to see what the real pressure is and go from there.

oil light normally blinks for 2 reason. low oil pressure or low oil level. if the level is good and since its a 2007 i would hope that it was getting pressure. so its prolly the sensor. you can either remove the sensor and have someone check it. electrician hopefully. or you can just replace it