I would first check fuses. Second, check for any codes in the system. To make a motor run you need air, fuel, and spark. Pull a spark plug and use a spark plug tester while cranking the motor to determine if you have spark. If no spark, and you have replaced crank sensor I would suspect ignition control module unless you have coil over plugs. Also, when you turn the key on, listen for the injectors squirting fuel. Hard to diagnose with such little info. Just know your are missing one or more elements causing it not to start. If there is a mechanical issue inside the motor this could also cause a no start condition.
SOURCE: Engine died while driving, cranks but won't start.
not all scanners a created equal. You need to check for trouble codes...............but it must be fixec by now.
SOURCE: Vehicle dies while driving down the road.
could it be the A/C pump kicking in. might be boging down the motor or electrical circuit, not letting the injectors get enough power. This could happen if the bearings are going bad in th A/C pump or there is a short in it. Just an idea. sounds like you have done the main components.
SOURCE: my engine shuts off while im driving
Check ecm for number 1228253. If it has this one in it you will have a cutting off problem. Gm replaced these with #16198264 The cam sensor magnet on the cam gear will deteriorate and give problems. This will require removal of the timing cover.
SOURCE: "Cranks, but won't start". Replaced fuel pump, CKP, ICM & nothing
If the engine
cranks over normally when you attempt to start you car, but the engine
does not start, the problem may be NO FUEL, NO SPARK or NO COMPRESSION.
The engine needs adequate fuel pressure, a properly timed spark and
normal compression to start.
1) To find why the engine won't
start, remove the air inlet tube from the throttle body, push the
throttle open and spray a small amount of aerosol starting fluid into
the engine. Crank the engine. If it has spark and compression but NO
FUEL, it will start and run a few seconds before dying. If it does NOT
start, it probably has NO SPARK.
2)Another method to check for spark is to pull a spark plug wire
off of a spark plug (if it has plug wires, coil-on-plug ignitions do
not) and place the open end of the plug wire near a metal surface on
the engine. Have a helper crank the engine while you watch for a spark.
DO NOT hold the wire while doing this as it can shock you. If you see a
spark, the problem is not spark, but most likely NO FUEL or NO
COMPRESSION. If you do not see a spark, the problem is in the IGNITION
CIRCUIT.
3)Proper fuel pressure is critical for fuel injected engines
to start and run. You should hear the fuel pump inside the fuel tank
buzz for a couple of seconds when the ignition is turned on (no buzz
means the pump is not running and the engine is not getting fuel). You
can smell the tailpipe for gasoline vapors after cranking the engine.
If you smell gas, the problem is likely not fuel but NO SPARK. You can
also remove the plastic cap and press the schraeder valve test fitting
on the fuel rail to see if there is any fuel pressure to the engine
(not a very accurate test because fuel pressure must be at a certain
level for the engine to start, for that you need a gauge). Even so, no
fuel at the fuel rail would tell you fuel is not getting to the engine..
SOURCE: 2005 nissan frontier wont start i have fuel and
Take one of the spark plugs out and let us know what it looks like. Dry and light grayish tan means you have spark but fuel supply problems. Wet spark plug that smells like gas means it is more of a spark issue.
Good Luck
79 views
Usually answered in minutes!
×