Tilt wheel stuck I the up postion,How do you fix it

jerk wheel up and down while pulling on tilt lever sometimes thing have to be a bit aggressive

The tilt housing inside the column is bolted on with 4 screws. They have came loose causing your delimma. Have a trusted repairman fix this for you for the air bag system is no task for the unqualified novice

There has to be a short in one of the wires or one of them are almost completly broken. When you tilt your wheel its probally makeing contack and isint when you dont tilt your steering wheel

your steering wheel adjuster is blocked or stuck up thats why it doesnt freely move to the max. take off cover/ check condition and or lubricate it.

The tilt is broken needs to be replaced. Part # 05083729AA Chrysler Dealer around $38. If you don't have a Chilton's Manual nows the time to buy one to remove the steering wheel & airbag system.

on the left side of steering column theres a lever. it located behind the singal light lever, if you pull back on lever you should be able to tilt wheel into postion you need, good luck hope this helps.

the dimmer switch is what your talking about im assuming its on the column if so the steering wheel will have to come off first to replace the switch when you get new switch refer to service manual on how to replace it

disconnect battery and block wheels lower tilt wheel and un thread tilt release handle remove screws that hold lower colum cover on and remove cover you will have to remove the panel above the pedals if it has one top colum cover is only held on by key tumbler to get tumbler out turn key to run postion and press in the silver button on the bottom of the housing and use key to remove the tumbler once tumbler is out shift to 1 and tae cover off remove 2 tork screws holding switch on and disconnect connectors reverse order for installation let me know how you make out

Most often, the stuck steering wheel is a result of a faulty 'tilt relay switch.' If you attempt to use the tilt switch and you can hear a clicking/whirring noise, then its your relay switch, if not, it may be the motor that is broken.

Did u try turning the steering wheel slightly in either direction? The steering wheel can 'jam' causing the key to seem stuck in the ignition. Simply turning the steering wheel a bit relieves the pressure and the key will turn. Let me know if this works for u