Question about Mitsubishi Cars & Trucks

1 Answer

Mitsubishi l200 working what when i am going with 120 speed up to 60or 70 km not ani problam after 70km drive when i am comeing slow my pick up sadnley stoping by pls help me

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Mitsubishi Master
  • 7,515 Answers

For better result download the pdf file
MITSUBISHI

Posted on Apr 26, 2016

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Anonymous

  • 7 Answers

SOURCE: Mitsubishi Pick up

check your transmission fluid, tune up plugs wires etc,good luck

Posted on Jun 20, 2008

emissionwiz

Marvin

  • 85216 Answers

SOURCE: engine light and the D drive light flashing

it is very poss the transmission case connector is making a poor connection, remove the connector from outside the trans and see if it has any corrosion or loose pins, if problem persists replace the trans solenoid shift pack.

Posted on Jun 17, 2009

paul

  • 263 Answers

SOURCE: Hi folks, my problem is this:

throttle cable

Posted on Sep 27, 2009

Gerne Venter

  • 64 Answers

SOURCE: mitsubishi l200 4wheel drive light flashes

Hi, this is caused by a few things. It might be that the 4x4 switches on the transfer case are sticky or you do not have sufficient vacuum on the front diff actuator which is caused by a hole in one of the vacuum pipes or the vacuum solenoids not operating correctly. You can test the vacuum solenoids with your finger. Start the vehicle and pull off the vacuum pipes connected to the top of the vacuum solenoids. When 2wd is selected you should have vacuum on one solenoid and when 4wd is selected the vacuum should change to the other solenoid.

Posted on Nov 23, 2009

Anto Gasparevic

  • 246 Answers

SOURCE: 1997 jimmy has slow acceleration

Could be faulty speed contol sensor.

Posted on Dec 30, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Which was the performance of ford anglia 1966


their are 16 models for the anglia in 1966 using the higher hp /manual set up --Anglia 105E-123E Saloon model for Europe North America , 2-door sedan with manual 4-speed and 1198 cm3 / 35 40kW (47 54 hp / 48 54 PS);--------- Acceleration:0-30 km/h (s):2.20-40 km/h (s):3.50-50 km/h (s):4.60-60 km/h (s):6.60-70 km/h (s):8.50-80 km/h (s):10.90-90 km/h (s):140-100 km/h (s):18.50-110 km/h (s)24.40-120 km/h (s):34.7----------Drag times:0- 1/4mile (s):20.4speed at 1/4mile:103 km/h / 64 mph0- 1km (s):38.9------- Top speed: 132 km/h / 82 mph http://www.automobile-catalog.com/auta_perf1.php

Sep 25, 2016 | 1966 Ford Anglia

1 Answer

Engine 4d56 loose refs and go to idle


If this is a fly by wire throttle, pedal assembly may be failing.

Jun 01, 2016 | 2011 Mitsubishi L200 2.5

2 Answers

Why is the my r124 prime mover shaking after 70km to 80 km?


If the steering wheel is vibrationg it may be that the wheels need balancing. If the whole vehicle is shaking you need to check that wheel bols are properly tightened first. You might need to get steering/suspension checked .... before there is a bad fault developing

Jun 10, 2015 | Cars & Trucks

1 Answer

The RPM of my engine remains at 4000 while my speed is 120 km/hr


I guess that you have a manual transmission. If that is the case you have a clutch on the way out. Slow slippage that gets worse as the plate gets hotter. If an automatic it is possible that the overdrive is not holding due to low pressure in the box. Have a pressure test done on the box--- have the fault codes read. From experience 120 kph is around 3200rpm for most cars and the 800 rpm difference indicates that the o/dive is not working as it should.

Apr 02, 2013 | 2000 Toyota Camry

1 Answer

Mitsubishi Pajero (Montero) 2005 transmission light. After driving for approximately 20 km (~12.5 miles) at a steady speed of 120 km/h (~65 miles/hour) the red light of the transmission starts flashing. ...


Could be either or, or it could be neither. Is the "red light" a transmission temperature warning light? If so, the fluid is over heating and the heat sensor is turning the light on...Check fluid level and the condition of your fluid...if it's off colored and smells burnt, you better have it flushed, refilled and a new filter installed. Heat will kill a transmission faster than anything.
Check the transmission cooler, most montero's had a cooler installed on the front of the vehicle by the radiator...the cooling fins need to be clean, no bugs or debris so air flows through it. Have your vehicle scanned also, if you had a transmission code the computers memory will probably still have it stored, this will be helpful with further diagnosis.

Jul 16, 2011 | Mitsubishi Montero Cars & Trucks

1 Answer

My 2006 Freestar was hesitating (or sort of jumping) at around 70 km/h and then yesterday was doing the same when I got tried to excellerate at about 100 km/h (on the highway). By the time I got home it...


Sounds a lot like the fuel pump for a starter. When it acts up does the vehicle jerk or buck before picking up speed? I have also had the experience with just one spark plug wire or plug bad. You can check this by pulling each wire one at a time while engine is running. If the motor slows that plug and wire are fine. If no change in rpm check the plug and wire.

Jul 27, 2017 | 2006 Ford Freestar

1 Answer

Slow speed 2.7 toyota prado 2004 mo0del


May be low fuel pressure, or, much less likely, a bad fuel filter. Check your air filter, maybe even replace it. Check vacuum lines for leaks. Try a good fuel injection cleaner like Lucas brand. Maybe a gas line dryer (for water mixed with gas). You might have to test or have tested, your fuel injectors. Could be the throttle position sensor. MAP sensor. Choke may be sticking part way closed.

Aug 26, 2009 | 2004 Toyota Land Cruiser

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

113 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

Marvin
Marvin

Level 3 Expert

85216 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...