Fuel pump ? fuel pump relay ? Test the circuit . Fuel pump electrical circuit diagnosis no fuel pressure testing GM
SOURCE: 94 GMC truck diesel starts,runs and then dies and will not start
I have the same problem and have trouble codes 35 and 36. I found out that there is a computer module that needs replaced as it sits low in a valley and gets hot and seperates. I am reseaching about the a/m fix that installs the new module away from heat.
SOURCE: 99 GMC Sierra Pickup: Crank but no start. starts
The theft light issue is a good observation. Have you replaced the key tumbler or an ignition component lately? Has there been a lightning storm close very recently?
What the flashing security light is indicating is an attempt to relearn the key you are using.
Turn the key to run position, allow light to flash for 10 minutes, when light stops flashing turn ignition to OFF position for 5 seconds, turn ignition to run position and start over. Do this for 3 consecutive cycles, the the theft system will relearn the key cylinder code and store it once again.
Try that first before you go any further.
Let me know what you find.
Regards,
SOURCE: 1998 GMC Sierra- runs rough then stalls when
had this problem on my neighbors 98 chevy truck with the same engine !!
it turnd out too be the fuel pressure regulator,you have too pull the upper intake too replace it!!
SOURCE: 96 gmc sierra hard to crank after 12-14 hours
that has a votec engine in it the fuel pressure is droping at knight and it takes 60 psi before the injectors will fire most likely cause fuel pump ,leaking injector ,or a feul pressure regulator
SOURCE: suburban stalls while driving
a bad crank sensor can cause this. shuts off while going down road, and will start about 10 min, later with no problems runs fine until it quits again. hope this helps,
1,030 views
Usually answered in minutes!
×